Small Parts Tech

Nautique•Orlando, FL

About The Position

The Small Parts Tech assists with the construction and preparation of small parts for boat production. Work may involve infusion molding, waxing, cleaning, inspecting, cutting fiberglass, maintaining molds, drilling holes, laminating, sanding, and buffing. The role prepares molds and parts for infusion and ensures finished parts meet quality standards before moving to production. The position follows direction from a supervisor, foreman, or lead and complies with OSHA and other safety procedures.

Requirements

Ability to drive a forklift.
Ability to inspect molds and identify defects or damage.
Ability to wear a respirator and required safety equipment.
Ability to use and maintain small hand tools, such as a grinder, scraper, razor knife, and blower.
Knowledge of production processes and quality control.
Active listening, reading comprehension, and speaking skills sufficient to understand work instructions and communicate information effectively.
Time-management skills and the ability to respect others’ time.
Judgment and decision-making skills to assess options and select appropriate actions.
Ability to work effectively independently or with a team.
Ability to perform tasks under time pressure and meet deadlines.
Strong attention to detail.
Ability to recognize when something is wrong or likely to go wrong.
Ability to bend at the waist and knees and stand for extended periods.
Ability to climb into and out of boat interiors.
Ability to lift 50 pounds when necessary.
Ability to see details at close range.

Responsibilities

Receive and prepare molds for infusion, including buffing and laying pre-cut fiberglass onto molds.
Secure fiberglass and cut it to fit, ensuring the mold is properly covered.
Ensure molds are properly gel coated and ready for infusion.
Prepare parts to move on to production and eliminate bubbles in applied fiberglass.
Follow instructions from the supervisor, foreman, or lead.
Use small hand tools, including scissors, razors, and knives.
Keep the work area clean and orderly.
Work with a team to complete daily tasks.
Lightly sand parts when necessary.
Inspect parts for completeness and compliance with quality standards.
Perform other duties as assigned by management.
Comply with OSHA and safety procedures.