Small Parts Tech

Nautique Boat Company Inc•Orlando, FL

About The Position

Nautique Boat Company, a subsidiary of Correct Craft, builds ski and wake boats and describes a history of marine-industry innovation and craftsmanship dating to 1925. The Small Parts Tech assists in constructing and preparing small parts, including work involving infusion molding, waxing, cleaning, inspection, fiberglass cutting, mold maintenance, drilling, laminating, sanding, and buffing. The role prepares molds and fiberglass parts for infusion and production, checks completed parts against quality standards, and follows safety procedures. The position reports to the Small Parts Manager and is classified as non-exempt. The work takes place in a non-climate-controlled environment where the ambient temperature may exceed the outside air temperature. The role involves standing for extended periods, bending, climbing into and out of boat interiors, using hand tools and personal protective equipment, and lifting up to 50 pounds when necessary. Nautique Boat Company is an equal opportunity employer and states that reasonable accommodations may be made for qualified individuals with disabilities unless doing so would create an undue hardship.

Requirements

Be able to drive a forklift.
Be able to inspect molds and identify defects or damage.
Be able to wear a respirator and other required safety equipment.
Be able to use and maintain small hand tools, including a grinder, scraper, razor knife, and blower.
Have knowledge of production processes and quality control.
Use active listening, reading comprehension, and speaking skills to understand and convey information.
Manage time effectively and respect others’ time.
Use judgment to consider the costs and benefits of potential actions.
Work effectively independently or as part of a team.
Perform tasks under time pressure and deadlines.
Have strong attention to detail and the ability to recognize when something is wrong or likely to go wrong.
Be able to work in a non-climate-controlled environment where ambient air temperature may exceed outside air temperature.
Be able to bend at the waist and knees, stand for extended periods, and climb into and out of boat interiors.
Be able to lift 50 pounds when necessary.
Have the ability to see details at close range.

Responsibilities

Receive and prepare molds for infusion, including buffing and laying pre-cut fiberglass onto the mold.
Secure fiberglass and cut it to fit, ensuring proper distribution and coverage of the mold.
Ensure molds are properly gel coated and ready for infusion.
Make sure parts are ready to move on to production.
Eliminate bubbles in fiberglass after it has been applied.
Follow instructions from the supervisor, foreman, or lead.
Use small hand tools, including scissors, razors, and knives.
Keep the work area clean and orderly.
Work with a team to complete daily tasks.
Lightly sand parts when necessary.
Inspect parts to ensure they are complete and meet quality standards.
Comply with OSHA and other safety procedures.
Perform other duties as assigned by management.