Shaft Technician

Cementation USA•Elko, NV

3d•Onsite

About The Position

The Shaft Technician provides effective and accurate survey control for shaft operations using plumb bobs, steel tapes, survey instruments, and auxiliary equipment. Under the direction of a Shaft Engineer and/or others, the technician prepares detailed procedures for installing construction components, as well as development and construction layouts that comply with established standards. The position supports shaft construction and development through survey work, layout preparation, material calculations, quality inspections, recordkeeping, and coordination of supplies. The technician follows operating procedures and environmental standards, contributes to health and safety practices, and works with a Manager to develop relevant personal and professional development goals. Work is approximately 20% in the office and 80% in mine operations.

Requirements

Technical degree or university degree in Mining Engineering, or equivalent experience.
Valid driver's certificate.
1–2 years of Mining Engineering or mining experience.
Knowledge of applicable workplace procedures, the five-point safety system, and worker responsibilities under the Occupational Health and Safety Act.

Responsibilities

Provide survey control, steady brackets, elevation tape brackets, and line and grade for stations under the direction of the Shaft Engineer; locate concrete forms and shaft furniture to required specifications.
Frame and install guides and brackets.
Work with Miners and Operations personnel to calculate construction materials and provide results to the Shaft Engineer or Technical Services Manager.
Work with the Shaft Engineer to plot results on plans and sections and review project drawings for accuracy and development goals.
Prepare construction and development layouts.
Create, compile, and enter data into official log books.
Inspect material quality, particularly steel match marks, fabrication, and concrete.
Perform torque tests.
Organize cap boxes and Magazine log books according to each shift's requirements.
Follow operating procedures to conform to environmental standards.
Provide data to the Shaft Engineer or Technical Services Manager for shaft-advance reports and coordinate supplies and quality control of shaft-sinking supplies.
Work safely, remain mindful of workers below, follow applicable workplace procedures and safety requirements, and participate in the Project safety program.
Ensure personal protective equipment is used as required and workers are made aware of hazards associated with improper use.
Work with the Manager to establish personal and professional development goals and a development program.