Ironworker- Old Ocean, TX

Turner IndustriesOld Ocean, TX
Onsite

About The Position

Turner Industries is seeking an experienced Ironworker for Capital work in Old Ocean, TX. Relocation and per diem are not available for this role; candidates must be local to the area. This is a 4-10's work schedule, subject to change. Candidates must pass a pre-employment background check and health/drug screening. NCCER certification is highly preferred.

Requirements

  • High school or equivalent
  • One (1) to four (4) years of experience in specified skill (depending on mechanic level)
  • Knowledge of ironworker tools and how to use them
  • Rigging skills including wire rope slings
  • Written pre-employment qualification test
  • Post-offer drug/alcohol screen and physical evaluation
  • Job site safety requirements as required by the client (clean shaven, long sleeves, steel toe boots, etc.)
  • Safety equipment as required by the client (hard hat, safety glasses, gloves, respirator, hearing protection, safety harness with lanyard, etc.)
  • Applicant/employee must not pose a direct threat to the health or safety of others in the workplace

Nice To Haves

  • NCCER certification is highly preferred
  • Some job sites may require NCCER certification

Responsibilities

  • Works as a member of a crew to raise, place and unite girders, columns and other structural-steel members to form completed structures and frameworks.
  • Off loads deliveries of structural material from the fabricator.
  • Sets up and breaks down hoisting equipment for raising and placing structural-steel members.
  • Fastens steel members to cable of hoist.
  • Signals worker operating hoisting equipment to lift and place steel member.
  • Guides member or rides on member in order to guide it into position.
  • Pulls or pries steel members into approximate position while member is supported by hoisting device.
  • Forces members into final position.
  • Aligns holes in member with corresponding holes in previously placed member.
  • Verifies vertical and horizontal alignment of members.
  • Bolts aligned members to keep them in position until they can be permanently bolted.
  • Cuts steel members to make alterations.
  • Perform additional assignments per supervisor's direction.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service