Ironworker - Deer Park, TX

Turner Industries•Deer Park, TX

1d•$31 - $31•Onsite

About The Position

Turner Industries is seeking experienced Ironworkers for nested capital projects work in Deer Park, TX. Relocation and per diem are not available for this role; candidates must be local to the area. This is a non-exempt role that reports to the Foreman. Assigned duties are according to specific procedures, and work is checked frequently. The Ironworker position works as a member of a crew to raise, place and unite girders, columns and other structural-steel members to form completed structures and frameworks.

Requirements

High school or equivalent
One (1) to four (4) years of experience in specified skill (depending on mechanic level)
Knowledge of ironworker tools and how to use them
Rigging skills including wire rope slings
Written pre-employment qualification test
Post-offer drug/alcohol screen and physical evaluation
Job site safety requirements as required by the client (clean shaven, long sleeves, steel toe boots, etc.)
Safety equipment as required by the client (hard hat, safety glasses, gloves, respirator, safety harness with lanyard, etc.)
Applicant/employee must not pose a direct threat to the health or safety of others in the workplace
TWIC REQUIRED
Must pass pre-employment background check, health/drug screening

Nice To Haves

NCCER certification is highly preferred
Some job sites may require NCCER certification

Responsibilities

Off loads deliveries of structural material from the fabricator
Sets up and breaks down hoisting equipment for raising and placing structural-steel members
Fastens steel members to cable of hoist
Signals worker operating hoisting equipment to lift and place steel member
Guides member or rides on member in order to guide it into position
Pulls or pries steel members into approximate position while member is supported by hoisting device
Forces members into final position
Aligns holes in member with corresponding holes in previously placed member
Verifies vertical and horizontal alignment of members
Bolts aligned members to keep them in position until they can be permanently bolted
Cuts steel members to make alterations
Perform additional assignments per supervisor's direction