Supervisory Logistics Management Specialist

Naval Air Systems Command•China Lake, CA

2d•Onsite

About The Position

You will serve as a Branch Head in the Configuration & Data Management Division at NAVAIRWARCENWPNDIV China Lake. You will plan, develop, implement, and manage a comprehensive, affordable, and effective support strategy for Software and/or Hardware Configuration and Data Management (CDM). The role also involves planning and monitoring integrated logistics support (ILS) for weapons systems and equipment, performing analysis and verification related to logistics support policies and requirements, and reviewing technical and program documentation. The position requires at least one year of specialized experience equivalent to the NM-03 grade level in the Federal Service or equivalent. This experience must include leadership and resource management in a collaborative environment; management of Hardware and/or Software CDM support strategies; technical direction and recommendations concerning configuration and data management techniques; and strategic communication to address obstacles or objections. This position requires U.S. citizenship, suitability for federal employment, and the ability to obtain and maintain an interim and/or final security clearance. Travel from the normal duty station to domestic and overseas locations may be required, including travel to remote or isolated sites and extended travel on military or commercial aircraft. The role is covered by the Department of Defense Priority Placement Program. The federal position offers access to a comprehensive benefits package; specific benefits depend on position eligibility and should be confirmed with the hiring agency.

Requirements

U.S. citizenship.
Must be determined suitable for federal employment.
Must participate in the direct deposit pay program.
Must successfully pass the E-Verify employment verification check if a new employee to the Department of the Navy.
Current federal employees applying for GS jobs generally must meet time-in-grade requirements; current federal employees applying for STRL Demo jobs generally must meet time-in-band requirements.
Must obtain and maintain an interim and/or final security clearance prior to entrance on duty.
Must be able to travel from the normal duty station to CONUS and OCONUS locations, potentially including remote or isolated sites, and travel on military and commercial aircraft for extended periods.
Males born after December 31, 1959, must be registered for Selective Service.
At least one year of specialized experience equivalent to the NM-03 grade level in the Federal Service or equivalent.
Experience performing in a leadership, manager, or coordinator role requiring acquisition, assignment, and management of resources and tasking in a team or collaborative environment to accomplish organizational objectives.
Experience planning, implementing, and managing a comprehensive, affordable, and effective support strategy for Hardware and/or Software Configuration and Data Management.
Experience providing technical direction, analyzing alternatives, and recommending configuration and data management techniques—including planning, identification, control, status accounting, and audits—in accordance with applicable DoD standards.
Ability to overcome obstacles or objections when presenting new information or direction through strategic communication, objective reasoning, and adapting the message to the intended audience.
Supervisors in the executive branch are required to review the 14 General Principles of Ethical Conduct at 5 CFR 2635.101.
MSP/PPP applicants must currently hold the required security clearance.

Responsibilities

Plan, develop, implement, and manage a comprehensive, affordable, and effective support strategy for Software and/or Hardware Configuration and Data Management.
Plan and monitor integrated logistics support for weapons systems and equipment.
Perform analysis and verification related to logistics support policies, procedures, concepts, specifications, and requirements.
Review and provide input to drawings, specifications, test plans, procedures, engineering change proposals (ECPs), waivers, and other documentation.