Mechanical Shell Remover

PCC Talent Acquisition Portal•Douglas, GA

About The Position

The Rough Finishing Operative performs one or more rough-finishing operations, including cut-off, blasting, water blasting, alloy type testing, snagging, green sorting, and marking. The operator is expected to perform all operations and operate equipment efficiently. The role is responsible for ensuring castings meet quality standards and for maintaining a clean, orderly, and safe work area. Work takes place in dirty conditions due to ceramic pieces and dust.

Requirements

High school education.
Ability to lift up to 30 pounds approximately 10–20 times per hour.
Use a chain hoist for heavier weights.

Nice To Haves

Rough Finish experience preferred.

Responsibilities

Check routings for proper identification and operational routing.
Operate a pneumatic knockout unit.
Cut off castings and trim excess gating.
Hand blast or water blast parts to remove excess ceramic material.
Check alloy type.
Perform snag grinding.
Apply proper markings to castings using the correct work instructions.
Visually inspect work for obvious defects.
Record daily work performed using operational codes.
Keep the work area clean, orderly, and safe, and follow all safety rules.
Maintain a positive work atmosphere through appropriate behavior and communication with customers, clients, co-workers, and supervisors.
Perform other duties as required by the Supervisor.
Ensure parts meet quality standards.
Work daily overtime and weekend overtime as necessary.