Manual Inspector

Ccs•Anaheim, CA

About The Position

The Manual Inspector performs receiving, first article, in-process, and final inspections of machine components. The role uses precision measurement tools and surface plate setups to assess dimensional accuracy, surface finish, cosmetic condition, and surface defects. The inspector interprets engineering drawings and applies GD&T in accordance with ASME/ANSI standards, records inspection data in QMS software, and prepares detailed nonconformance reports. The position requires sustained concentration and attention to detail during repetitive, high-precision work. The stated schedule is 6:00 am–2:30 pm PST. Compensation is $28.00–$38.00 per hour. The company describes itself as a people-focused, flat organization that values strong ideas, radical truth, and data-driven decision-making. It provides customer experience solutions for contact center organizations and strategic technology partners.

Requirements

High school diploma or GED, or an equivalent combination of education and experience.
At least 10 years of quality control inspection experience on machine components.
Proficiency with precision measuring instruments and surface plate setup.
Basic Microsoft Office skills, including Word and Excel, for data entry and documentation.
Experience maintaining inspection data in QMS software.
Sustained concentration and attention to detail during repetitive, high-precision work.
Ability to lift or carry up to 25 lbs. occasionally or intermittently.
Ability to push or pull 25–50 lbs. occasionally or intermittently.

Nice To Haves

Aptitude for learning CMM software and other quality data systems.

Responsibilities

Perform receiving, first article, in-process, and final inspections using precision measurement tools.
Inspect parts for cosmetic and surface defects under appropriate lighting and magnification.
Measure surface finish and report out-of-tolerance conditions.
Enter inspection data into QMS software with 100% accuracy.
Interpret engineering drawings and apply GD&T according to ASME/ANSI standards.
Write detailed nonconformance reports with measurements and photos, and ensure proper part segregation.