3rd shift 5166 Jumbo Machine Operator

International Paper•Griffin, GA

80d•$26•Onsite

About The Position

The Jumbo Machine Operator is responsible for operating and maintaining the 5166 Jumbo Machine to produce quality corrugated packaging products. This role involves ensuring all safety devices are functional, setting up and operating the machine according to procedures, monitoring production output, and performing quality checks. The operator will also be responsible for maintaining a clean work area and communicating any downtime to supervisors. This is a full-time, hourly position on the 3rd shift (11 pm - 7 am), with a Sunday startup at 10 pm.

Requirements

Must be willing to work alternate shifts, weekends, and daily overtime as required.

Responsibilities

Ensure all safety devices are in place and working properly.
Use center-line on set-up at all times.
Raise pre-feeder up and run back.
Zero machine, open machine, and lock out; start wash up.
Set anilox rolls to zero.
Pull old print dies.
Check flow card, print card, construction card and print die number.
Hang print die for next order.
Set pull rolls.
Set calibration and registrations from center line sheet.
Help crew members if necessary.
Close machine.
Ink machine.
Run box through to check all dimensions.
Set stacker and bundler for upcoming order.
Keep sheets picked up on stacker or feeder while running order.
Use the run procedures to assure machine run is performed correctly.
Start-up machine.
Control the machine speed to produce a quality product at a maximum level of output.
Check bundle count on first handful as it leaves the C/E.
Check to make sure that boxes are being glued properly.
Check stacking plan, load tags, and unit count on first load.
Perform all QMS checks.
At start up, set aside two bundles of quality boxes to use as replacement boxes for defects.
Pull all defectives found during inspection and replace with good box from bundles set aside.
Confirm that final count matches bundle spec. (Replace same number as defects pulled).
Count scrap boxes to confirm equal # of replacements. If this number is incorrect, add difference to final unit.
Check and fold up at least one box per unit.
Check and maintain constant ink and glue flow.
Watch for and react to jam-ups.
Stack all bad sheets for reuse; waste to scrap cart.
Keep work area neat and clean.
Inform supervisor of any downtime.
Use downtime to clean your work area.
Check to make sure the MDC system is operating correctly during the beginning, middle, and end of each order.
Willing to work alternate shifts, weekends, and daily overtime as required.