CNC Operator 1 - Tubulars (NIGHTS)

Benoit Premium Threading LLC•Houma, LA

20h•Onsite

About The Position

The function of a Tubulars CNC Operator is to manufacture quality finished products in accordance with the instructions of the work order. CNC Operators report to the Manager-Machine Shop-Tubulars and exercise authority over no other employee. Specific duties include, but are not limited to: Perform/document necessary machine maintenance prior to running equipment. Verify material to Work Order prior to machining to ensure that correct material is being used. Check all precision measurement instruments for current calibration status and report any outdated or damaged equipment to the Manager. Verify dial calipers against micrometers at the start of each shift, prior to use. Do not leave machine while in operating cycle. Document all pertinent machine information before switching programs. Verify holders and boring bars against the program setup sheets to ensure that all tooling is properly located and positioned. Keep all documentation in a clean and legible condition. Have all program changes approved by the Machine Shop Supervisor and ensure that a 1st Article Inspection is documented by a QC Specialist before proceeding. Report immediately any lathe malfunction to the Manager-Machine Shop. Proceed with care when removing work piece from machine to avoid damage to new connections. Identify any work completed by you by marking your assigned identification number on the machined part, using a yellow paint marker. Paint white and repair as soon as possible any product which is out of specification. Report any questionable machined dimension, or problems with material, to the Q.C. Specialist and/or manager. No earlier than 20 minutes before shift ends, clean and wipe down the machine. Remove shavings from the pan and put shavings into the shaving bin. Sweep the floor in your work area. Sign off on Work Order, Router form, and any other documentation as required by Benoit SOPs.

Requirements

1–2 years CNC machining experience preferred
General knowledge of CNC equipment and precision measuring equipment
Ability to read and interpret prints, drawings, and work instructions
Ability to verify part dimensions and document required checks
Strong attention to detail and quality awareness
Must be able to work in the United States without sponsorship, now or in the future.

Responsibilities

Perform/document necessary machine maintenance prior to running equipment.
Verify material to Work Order prior to machining to ensure that correct material is being used.
Check all precision measurement instruments for current calibration status and report any outdated or damaged equipment to the Manager.
Verify dial calipers against micrometers at the start of each shift, prior to use.
Do not leave machine while in operating cycle.
Document all pertinent machine information before switching programs.
Verify holders and boring bars against the program setup sheets to ensure that all tooling is properly located and positioned.
Keep all documentation in a clean and legible condition.
Have all program changes approved by the Machine Shop Supervisor and ensure that a 1st Article Inspection is documented by a QC Specialist before proceeding.
Report immediately any lathe malfunction to the Manager-Machine Shop.
Proceed with care when removing work piece from machine to avoid damage to new connections.
Identify any work completed by you by marking your assigned identification number on the machined part, using a yellow paint marker.
Paint white and repair as soon as possible any product which is out of specification.
Report any questionable machined dimension, or problems with material, to the Q.C. Specialist and/or manager.
Clean and wipe down the machine, remove shavings from the pan and put shavings into the shaving bin, and sweep the floor in your work area no earlier than 20 minutes before shift ends.
Sign off on Work Order, Router form, and any other documentation as required by Benoit SOPs.