CNC Operator 1

Benoit Premium Threading LLC•Houma, LA

11h•Onsite

About The Position

The function of CNC Operator is to manufacture quality finished products in accordance with the instructions of the work order. CNC Operators report to Manager-Accessory Manufacturing and exercise authority over no other employee.

Requirements

1–2 years CNC machining experience preferred
General knowledge of CNC equipment and precision measuring equipment
Ability to read and interpret prints, drawings, and work instructions
Ability to verify part dimensions and document required checks
Strong attention to detail and quality awareness
Must be able to work in the United States without sponsorship, now or in the future.

Responsibilities

Report to the Machine Shop Supervisor to be assigned to a workstation and receive written work instructions.
Follow all company policies and regulations concerning conduct and safety.
Perform and document any necessary machine maintenance prior to running equipment.
Verify material to Work Order prior to machining to ensure that correct material is being used.
Check all precision measurement instruments for current calibration status and report any outdated or damaged equipment to the Manager.
Verify dial calipers against micrometers at the start of each shift, prior to use.
Do not leave the machine while in operating cycle.
Document all pertinent machine information before switching programs.
Verify holders and boring bars against the program setup sheets to ensure that all tooling is properly located and positioned.
Keep all documentation in a clean and legible condition.
Have all program changes approved by the Machine Shop Supervisor and ensure that a 1st Article Inspection is documented by a QC Specialist before proceeding.
Report immediately any lathe malfunction to the Machine Shop Supervisor.
Proceed with care when removing work pieces from machine to avoid damage to new connections.
Identify any work completed by you by marking your assigned identification number on the machined part, using a yellow paint marker.
Paint white and repair as soon as possible any product which is out of specification.
Report any questionable machined dimension, or problems with material, to the QC Specialist and/or manager.
Not earlier than 20 minutes before the shift ends, clean and wipe down the machine. Remove shavings from the pan and put shavings into the shaving bin. Sweep the floor in your work area.
Sign off on Work Order, Router form, and any other documentation as required by Benoit SOP.
Adhere to all company policies and be ON-CALL as required.