Carpenter - AGL

Ahtna•Tamuning, GU

1d•Onsite

About The Position

This position will require someone to perform tasks involving physical labor indoors and outdoors, including the movement of material, equipment, and parts between production areas, operating hand/power tools of all types, including air hammers, surveying, and measuring equipment, and a variety of other equipment and instruments. May clean and prepare sites, dig trenches, set braces to support the sides of excavations, erect scaffolding, and clean up rubble and debris. May assist other craft workers. This is a field position may require travel to various areas in Guam; hours worked while in travel status could be up to 12 hours per day. There are full-time and part-time positions available! These positions are located in Guam.

Requirements

High School Graduate or General Education Degree (GED)
Three (3) years of experience as a Carpenter
Knowledge of construction machines and tools, including their designs, uses, maintenance, and practical application use
Valid Driver’s license with the ability to be covered under company vehicle policy and the ability to travel to local facilities
Ability to pass background checks by various Federal Agencies (e.g. DOD, DHS, FAA, etc.) to obtain security access badges
United States Citizen or Permanent Resident

Nice To Haves

Technical school in the art of carpentry
OSHA 10 Training Certificate
Knowledge and experience with Alaska Native cultures
Shareholder Preference: Pursuant to PL 93-638, as amended, preference will be given to qualified Ahtna Native Corporation Shareholders, Descendants, and Spouses in all phases of employment.

Responsibilities

Perform rough or finish carpentry work
Ability to lay out a project mathematically
General knowledge and ability to perform other disciplines such as painting, plumbing, electrical, excavation sheetrock installation, and finishing
Assist and coordinate with other team members to complete tasks on time and within budget
Signal equipment operators to facilitate alignment, movement, and adjustment of machinery, equipment, and materials
Spray materials such as water, sand, steam, vinyl, paint, or stucco through hoses to clean, coat, or seal surfaces
Tend machines that pump concrete, grout, cement, sand, plaster, or stucco through spray guns for application to ceilings and walls
Tend pumps, compressors, and generators to provide power for tools, machinery, and equipment or to heat and move materials such as asphalt
Build and position forms for pouring concrete and dismantle forms after use using saws, hammers, nails, or bolts
Clean and prepare construction sites to eliminate possible hazards
Control traffic passing near, in, and around work zones
Dig ditches/trenches, backfill excavations, and compact/level earth-to-grade specifications using picks, shovels, pneumatic tampers, and rakes
Erect and disassemble scaffolding, shoring, braces, traffic barricades, ramps, and other temporary structures
Load, unload, and identify building materials, machinery, and tools and distribute them to the appropriate locations according to project plans/specifications
Measure, mark, and record openings and distances where construction work will be performed
Raze buildings and salvage useful materials
Demonstrate various architectural finishes, such as but not limited to carpeting, ceiling tile, drywall, etc.
Patch, repair, and install various Architectural finishes, such as, but not limited to, carpeting, ceiling tile, drywall, etc.
Read and interpret plans, instructions, and specifications to determine work activities
Perform any other duties as assigned by management