Assembler II (3rd shift) - Cable Tray

Eaton Corporation•Reno, NV

59d•Onsite

About The Position

Eaton’s ES GEIS BLD division is currently seeking an Assembler II (3rd shift) - Cable Tray at their Reno, NV location. The Assembler II position is primarily focused on assisting and setting up for Welders in the Cable Tray department. The Assembler II will assemble and stack/band Cable Tray ladders. The Assembler II will handle materials and parts up to 50-pounds frequently throughout the shift. This role involves performing simple repetitive assembly of parts and components using bolts, screws, hand tools, clips, and other fastening devices. Work is performed under close supervision and may involve working from models, samples, or simple diagrams. The position also supports facility Continuous Improvement and LEAN initiatives, including maintaining 5-S principles and tracking visual management tools. Encouragement and participation in Kaizen improvements and events are also part of the role.

Requirements

Consistenly lift 50 pounds
Able to stand on feet continuously during working shift.
Must be able to wear required personal protective equipment as required by company policy and procedure.
Must be able to handle materials up to 50 pounds
Require fine manipulation of hands with repetitive motion.
Troubleshoot and resolve problems as they arise.
Handle materials that pertain to large part construction, weighing 50 pounds multiple times per day.
Candidates must reside within 50 miles of the work location to be considered for this position. Active-Duty Military Service member candidates are exempt from the geographical area limitations.
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.

Nice To Haves

Previous experience in a manufacturing environment
Experience confirming that parts conform to specs using measuring tools.
A minimum of 6 months of experience with forming or bending machines
A minimum of 6 months of experience reading drawings or blueprints

Responsibilities

Perform simple repetitive assembly of parts and components
Use bolts, screws, hand tools, clips and other fastening devices
Work under close supervision and may work from models, samples, or simple diagrams
Handle 50-pound parts to assist with large part construction
Support all facility Continuous Improvement and LEAN initiatives
Maintain 5-S (sort, set in order, shine, standardize, sustain) throughout shop floor and office areas.
Track and sustain all visual management tools such as, but not limited to: layered audits, Overall Equipment Effectiveness (OEE) boards, and any additional LEAN tools that are deemed necessary to provide direction, goals and status to the shop floor.
Encourage, support, and actively participate in Kaizen improvements and events throughout the facility, department, and area of responsibility.