Weld Machine Inspector/Quality Lead 2nd shift

Batesville Tool & Die Inc•Batesville, IN

3d•Onsite

About The Position

This position reports to the Quality Manager then Vice President (VP) of Quality and is responsible for inspecting parts, verifying Poka-Yokes, and identifying and correcting quality risk. The role requires a GED or High School Equivalency diploma and the ability to read micrometers, calipers, and indicators. Blueprint reading, knowledge of computers, Coordinate Measuring Machine (CMM), and cut & etch process are a plus.

Requirements

Must be able to read micrometers, calipers, and indicators.
General Educational Diploma (GED) or High School Equivalency (HSE) diploma.
Knowledge of computers.
Working knowledge of all poka-yokes.
Competent on how to use and train others on correct use of torque wrenches, force testers, calipers, indicators, and all other inspection equipment used for weld machine inspection.
Ability to organize and manage all inspection and poka-yoke checks.
Conscientious in being at work when scheduled and on time.
Perform the highest possible amount of quality work in the least or standard amount of time.
Follow documented processes and procedures.
Do good quality work the first time, avoiding rework.
Make good quality decisions as it relates to the job functions.
Exhibit problem solving skills.
Be knowledgeable of and adhere to all safety rules and regulations.
Always be conscious of the safety implications of one's actions; consistently observe safety regulations and wear required safety equipment.
Safely and efficiently use any assigned equipment.
Participate in and support lean manufacturing programs and principles.
Adhere to 5S: Sort, Set in Order, Shine, Standardize, Sustain.
Comply with and support any environmental policies and programs.
Do not bring any environmentally hazardous substances or compounds into BTD and is always conscious of the impact on the environment.
Support and adhere to Technical Specification (TS) and International Organization for Standardization (ISO) activities and procedures.

Nice To Haves

Blueprint reading.
Knowledge of Coordinate Measuring Machine (CMM).
Knowledge of cut & etch process.

Responsibilities

Perform first and last piece layouts in a timely manner.
Accurately read part prints.
Understand gage calibration, and know when a gage is in need of calibration or repair.
Manage assembly hold area.
Carefully audit multi-out parts to verify labeled correctly.
Actively assist in training of operators in quality checks.
Ensure green tag is properly completed and at correct work center at the start of a run.
Precisely monitor quality checks during production.
Communicate accurately all pertinent employee quality performance information to group leader and above.
Ensure gages that are needed for each job are at the specified work center.
Have working knowledge of all poka-yokes.
Accurately understand the machine reset process and how to ensure no defective parts get out during this process.
Be competent on how to use and train others on correct use of torque wrenches, force testers, calipers, indicators, and all other inspection equipment used for weld machine inspection.
Keep first/last piece part bins up to date (last 2 production runs).
Organize and manage all inspection and poka-yoke checks.
Perform any other duties as assigned with enthusiasm and without complaint.