Shell Operator, Swing Shift (Aluminum) - Ogden, UT

PCC Talent Acquisition Portal•Ogden, UT

12d•Onsite

About The Position

Responsible for the production of shell molds. This role involves various stages of mold preparation, including hanging wax setups, preparing and applying slurries and stuccos, applying core packs, and utilizing the dry time system. The position also includes the "tear down" of setups, dewax operations, and maintaining lot integrity and proper paperwork. The Shell Operator will also assist in other areas as needed and must be able to work in a production environment.

Requirements

Able to work in a production environment.
Able to read and comprehend English.
Able to add and subtract two digit numbers and to multiply and divide with tens and 100s.
Able to lift and carry up to 35 lbs. frequently.
Able to read and interpret documents, such as safety rules, operating and maintenance instructions, and procedure manuals.
Able to read and comprehend simple instructions, short correspondence, and memos.
Able to write simple correspondence.
Able to apply common sense understanding to carry out instructions furnished in written, oral or diagram form.
Able to deal with problems involving several concrete variables in standardized situations.
Able to complete OSHA forklift certification through PCC Structurals, Ogden.
Able to complete PCC Shell certifications required in grade system.
Near vision requirements are Jaeger J1 in one eye, at no less than 12 inches; or equivalent, or Jaeger J2 in one eye, at no less than 16 inches.
Able to communicate effectively with co-workers.
Willing to work overtime.
Complies with company and departmental policies and procedures, including company’s attendance policy.
Able to meet individual productivity requirements.
Able to meet internal quality requirements.

Nice To Haves

High School Diploma or G.E.D.
1 month of training or experience.

Responsibilities

Hangs wax setups on conveyor line.
Prepares, maintains and tests slurries per procedures.
Applies correct slurries and stuccos to patterns per procedures through manual dipping or robot operation.
Applies core pack to patterns.
Uses the dry time system per procedures.
Performs “tear down” of setups from hangers (Takes setups off conveyor line and cleans shell off of hangers using hammer and air tool chisel).
Performs dewax operations using proper procedures.
Blows off excess sand per procedures.
Maintains lot integrity.
Ensures paperwork is done properly.
Helps other areas as needed.