Sheet Metal Fabricator, Architectural - North Slope, AK - rotational

NANA Construction•Prudhoe Bay, AK

1d•Onsite

About The Position

Fabricate, install, and maintain architectural sheet metal systems, wall panels, cladding, and trim components for commercial and industrial construction projects. Ensure all work is completed safely, efficiently, and in accordance with project specifications, quality standards, and applicable building codes.

Requirements

High School Diploma or GED equivalent or ten (10) years related experience will be considered.
Minimum two (2) years directly related fabrication experience.
Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals, write routine reports and correspondence, speak effectively before groups of customers or employees of organization.
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals, compute rate, ratio, and percent and to draw and interpret bar graphs.
Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form, deal with problems involving several concrete variables in standardized situations.
Be willing to learn as well as mentor others in regards to work task completion.
Committed to keeping one self and those around safe at all times, including stopping work if unsafe conditions arise.
Be able and willing to perform other duties and job functions. Often times other work crews will need assistance which requires all employees that are available to assist these other job functions to achieve successful project completion.
Steel toed boots required on the job.

Nice To Haves

Driver’s License and an acceptable driving record for the past three (3) years to be eligible under company vehicle insurance policy preferred.

Responsibilities

Install insulated and non-insulated wall panel systems, trim packages, and related architectural components.
Measure, locate, and mark cutting and bending lines in accordance with project specifications and shop drawings.
Set up, operate, and maintain fabrication equipment, including brakes, rolls, shears, drill presses, and related machinery.
Utilize hand tools and power tools safely and effectively while adhering to all site-specific safety requirements and company policies.
Design, fabricate, and construct templates, patterns, and layouts as required for field and shop applications.
Inspect completed work and verify compliance with project specifications, quality standards, and installation requirements.
Monitor, organize, and maintain materials, equipment, and inventory to support project efficiency and productivity.
Assemble, fit, and secure components using appropriate hand and power tools to meet quality and performance standards.
Perform work safely at heights, including operating from scaffolding, aerial lifts, and other elevated work platforms.
Immediately report all Incidents/Accidents, no matter how small, to their Supervisor.
This position has no supervisory responsibilities.
Other duties that are pertinent to the department or unit’s success also may be assigned.