TRW - Repairman

Ameren•Labadie, MO

6d•Onsite

About The Position

Ameren Missouri has been providing electric and gas service for more than 100 years, and our electric rates are among the lowest in the nation. Ameren Missouri's mission is to power the quality of life for our 1.2 million electric and 132,000 natural gas customers in central and eastern Missouri. Our service area covers 64 counties and more than 500 communities including the greater St. Louis area.

Requirements

Qualification standards as established in the Apprenticeship Program.
Must satisfy requirements as prescribed in the Supplementary Agreement on Uniform Practices Regarding Promotion to Repairman Jobs (if no graduating apprentice is available).
Must be accurate, steady and calm in emergencies.
Possess normal physical strength and endurance.
Have no color deficiency in vision.

Responsibilities

Perform a general range of electric arc and gas welding and cutting, brazing, pipefitting and insulation installation and/or removal on all varieties of power plant equipment.
Perform other maintenance work on heavy mechanical equipment, such as replacement of liner plates in fans, coal chutes and hoppers; welding repairs to castings and equipment; fitting and welding of all sizes of piping and valves, including items such as measuring, laying out, cutting, threading, bending, fitting and installation of pipe and tubing, replacement of flange, valve, and heater gaskets; valve repacking, repair and overhaul; cleaning and replacement of condenser and heat exchanger tubes; where applicable, repair of traveling water screens.
Perform refractory and insulation work including furnace wall insulation and protective covering; insulation coverings on furnace wall fire side linings, slag tanks and hoppers; gas and hot air ducts and breeching; precipitator casings, main, reheat, and extraction steam lines; boiler feed piping; steam and condensate drains; feedwater heaters and storage tanks; turbine casings, steam chests and valves.
Take welder qualification tests as required.
Work from drawings and sketches.
Check to ensure that equipment to be worked on has been properly isolated and protected.
Obtain required materials from storeroom.
Set up rigging and operate lifting equipment.
Erect and work from scaffolds.
Operate and/or use mobile equipment, shop equipment, portable power tools, other portable tools, hand tools and test equipment as required to accomplish assigned jobs.
Prepare reports of work done accompanied by sketches, if necessary; complete such forms as may be required.
Work alone or in combination with other Repairman (Certified) or Repairman classifications when assigned.
Do similar and less skilled work as required.
Carry out prescribed safety precautions and safeguards for the protection of himself and others.
Check for explosive gases before operating torches.
Observe and ensure that those temporarily under his direction observe safety instructions issued or applicable.
Perform work without disturbing other equipment.
Execute orders quickly and properly.
Ensure accuracy of work within required tolerances or specifications.
Exercise special care and watchfulness to avoid errors in the repair and assembly of equipment.
Proper use and care of a wide variety of tools, material, and equipment.
Disposition of surplus and scrap materials after each job and keeping areas where work is performed clean and orderly to maintain an atmosphere conducive to good work practices and safety.