Quality Tech

Howmet Aerospace • Brea, CA

1d • Onsite

About The Position

This position requires the dimensional/visual/mechanical property inspection of parts throughout various stages of manufacturing up to and including final acceptance. Various gages and inspection equipment will be used to determine conformance to requirements along with identifying and reporting defects per established procedures and practices.

Requirements

• High school diploma or GED.
• Good communication and basic math skills.
• Familiarity and experience with various gages and measuring equipment
• Five years of related experience

Responsibilities

• Read prints/specifications, measure parts and works with the following types of gages to determine if product is in conformance: pin gages, micrometers (various types), drop gage indicators, calipers, hardness tester, tri-rolls, optical comparator and other equipment or gages as needed
• Visually inspects sample parts, usually under a magnifying glass or Microscope, from each pan and identifies any nonconforming parts in the lot. If the nonconforming parts exceed acceptance criteria, the entire lot is rejected via written documentation.
• This work can be performed in the Inspection area as well as on the shop floor.
• Document results on applicable quality documentation
• Actively participates in continuous improvement activities to assist team in meeting goals related to quality, cost and delivery.
• Train other inspectors to the functions required for that position.
• Works with minimal supervision to independently perform the job of Inspector A in its entirety as assigned.

What This Job Offers

• Job Type: Full-time
• Career Level: Mid Level
• Education Level: High school or GED