Press Tech (Tandem and Transfer Press Operator)

Flex-N-Gate • Royal Oak, MI

1d

About The Position

Flex-N-Gate is seeking a Press Tech to operate and set up tandem lines, transfer presses, and/or automatic presses. The work includes setting up coil-feed lines and blank bunks or carts, programming and adjusting end-of-arm tooling, and configuring feed equipment and conveyors. The Press Tech is responsible for press operation and the safety of assigned coworkers, and supports job changeovers, production readiness, equipment performance, and product quality.

Requirements

• Pass a written mechanical aptitude and knowledge test.
• Be able to read instructions and perform tasks as directed.
• Have a basic understanding of positive and negative numbers and how they relate to robots.
• Have a basic understanding of metric and standard (English) measurement systems.
• Be able to read, comprehend, and navigate multiple HMI screens.
• Communicate in technical terms and relay information to people involved in equipment operation and maintenance.
• Use hand tools, lubricants, and other hand devices as needed for safe operation.
• Demonstrate a good attendance record.
• Be able to lift at least 50 pounds and continuously bend, twist, squat, climb, kneel, stand, or walk in close, confined surroundings.
• Have at least a high school diploma or equivalent, including high school math and reading proficiency.
• Have extensive troubleshooting ability with production equipment and programs to achieve maximum efficiency.
• Be able to work mandatory overtime as required, 6–7 days per week.

Nice To Haves

• Additional education, from college coursework to training seminars in a related field.
• Knowledge of Fanuc and ABB robots, HMS transfer systems, and die-protection units such as Rexcon, Smart-Pac, and Wintriss.
• Knowledge of coil feed lines, straighteners, feeder set and pitch adjustments, and pilot release.

Responsibilities

• Operate and set up tandem lines, transfer presses, and/or automatic presses.
• Control press operation and be responsible for the safety of employees assigned to work with the presses.
• Operate lift trucks and overhead cranes to place or remove dies, coils, blanks, and other equipment needed for JCO or pre-staging.
• Participate in JCOs from start to finish.
• Perform initial setup and determine corrective actions to ensure automation equipment meets performance capability.
• Maintain end-of-arm tooling where applicable.
• Load coils onto the uncoiler and thread them through the feed line, ensuring proper alignment to the die and adjusting set and pitch.
• Install and adjust end-of-arm tooling where applicable to ensure proper picking and placement.
• Set up items needed for production, including part-exit conveyors, chutes, scrap shakers, die lubricant, and sensors.
• Pre-stage the next scheduled job while equipment is in production mode, where applicable.
• Verify at least once per hour that produced parts meet quality standards and report concerns to the supervisor.
• Adjust, calibrate, align, and modify automation systems and components when required.
• Advise the supervisor when equipment cannot meet product quality standards and contact appropriate skilled trades when routine procedures do not resolve the problem.
• Perform other miscellaneous duties and work in other classifications as assigned.

Benefits

• Medical, dental, prescription, vision, life, and disability insurance
• Flexible spending account
• 401(k) retirement savings plan with company match
• Safety training, new-hire orientation, and continuous learning and development programs
• Tuition reimbursement
• Paid holidays and vacation time

What This Job Offers

• Job Type: Full-time
• Education Level: High school or GED