Pipefitter/Fabricator - Port Allen, LA

Turner Industries•Port Allen, LA

3d•$34 - $36•Onsite

About The Position

This position is located at the Port Allen, LA Pipe Fabrication Shop. The Pipefitter/Fabricator works under the direction of a foreman, assists skilled workers in performing their assigned duties, and performs a variety of other tasks. The role requires the ability to interpret shop sketches, identify materials, and fabricate pipe spools from detailed sketches.

Requirements

Must be able to pass a pipe fitters test.
Pre-employment on-site qualification test.
Post-offer drug/alcohol screen and physical evaluation.
OSHA approved corrective eye wear (Z87).
Job site Personal Protective Equipment (PPE) requirements (hearing protection, safety glasses, long sleeve shirt, gloves, steel toe boots, etc.).
Ability to interpret shop sketches.
Ability to identify material listed on sketches.
Ability to fabricate pipe spools from detailed sketches.
Ability to read and sign off on JSA.
Ability to gather material listed on sketch to fabrication table.
Ability to record heat numbers from fittings to the sketch if required.
Ability to lay out for inside and outside diameter nozzle attachments.
Ability to prep pipe and fittings with pneumatic grinders for fit up.
Ability to use a plasma or oxy/fuel cutting torch.
Ability to clean out inside diameter with compressed air after fit up.
Math skills required to add and subtract dimensions, figure inside/outside arc of ells, figure outside diameter rolls for spool orientation such as attachments, flange two holes.
Ability to maintain a clean work area.
Ability to climb ladders, scaffolds, structures, etc. above and below ground level.
Ability to maintain balance on ladders, scaffolds, structures, etc.
Ability to reach in all directions, handle and manipulate objects and materials.
Ability to coordinate the movements of eyes, hands and fingers to operate tools and equipment.
Ability to lift 30 to 50 pounds from ground level, waist level, and/or overhead.
Ability to carry objects, tools, equipment, etc.
Ability to stand, sit, walk, push, pull, bend, kneel, crouch/squat, crawl.
Ability to see with or without correction.
Ability to hear with or without correction.
Ability to follow set procedures and standards.
Ability to apply basic mathematical skills.
Ability to plan work and select proper tools.
Ability to read and interpret load charts.
Ability to judge distances and slopes accurately.
Ability to follow oral and/or written directions.
Ability to read.
Ability to write.
Ability to recognize and report safety hazards.

Nice To Haves

One (1) to four (4) years of experience in specified skill.

Responsibilities

Interpret shop sketches and identify material listed on sketches.
Fabricate pipe spools from detailed sketches.
Read and sign off on Job Safety Analysis (JSA).
Gather material listed on sketch to fabrication table.
Record heat numbers from fittings to the sketch if required.
Lay out for inside and outside diameter nozzle attachments.
Prep pipe and fittings with pneumatic grinders for fit up.
Use a plasma or oxy/fuel cutting torch.
Clean out inside diameter with compressed air after fit up.
Apply basic mathematical skills to add and subtract dimensions, figure inside/outside arc of ells, and figure outside diameter rolls for spool orientation such as attachments and flange two holes.
Maintain a clean work area.