NCCER Electrician Journeyman

Kiewit•Shepherd, TX

20h•Onsite

About The Position

Plan, lay out, install, test, and repair wiring, electrical fixtures, apparatus, motors, equipment, and control systems in accordance with applicable plans, specifications, codes, and industry standards. This is a skilled position based in a construction or industrial environment. The role requires NCCER Electrical certification and the ability to work irregular hours, weekends, overtime, and holidays as required. Candidates must pass pre-access drug and alcohol testing and a fit-for-duty medical examination.

Requirements

NCCER Electrical certification.
May require a high school diploma or equivalent and previous years of experience in the field or a related area.
Ability to pass pre-access drug and alcohol testing and a fit-for-duty medical examination.
Ability to constantly move about a construction or industrial site and stand, walk, sit, reach, stoop, kneel, crouch, and/or crawl.
Ability to work in changing outdoor weather conditions, and in noisy, dusty, confined, cluttered, or uneven environments.
Ability to climb and maintain balance on formwork, steel formwork, stairs, ladders, and scaffolds; use ladders, mechanical platforms, manlifts, or scaffolds to reach work areas, potentially exceeding 200 feet.
Ability to move items weighing up to 50 pounds across a construction or industrial site.
Must have the required tools.
Ability to work irregular hours, weekends, overtime, and holidays as required.

Responsibilities

Interpret drawings, sketches, software, and plans; determine appropriate work procedures, tools, and equipment to troubleshoot and repair problems.
Measure, cut, bend, thread, assemble, and install electrical conduit; weld supports; install cable and duct banks; and make terminations.
Install and fasten control and distribution apparatus in place.
Test and start up systems and check circuit continuity to ensure electrical compatibility and component safety.
Observe installed equipment and systems to identify hazards and determine whether adjustment, relocation, or replacement is needed.
Pull wire through conduit as required and connect wiring to lighting fixtures and power equipment.
Work with high- and low-voltage systems.
Disassemble and repair defective electrical equipment or systems.
Operate electrical and mechanical hand tools, power tools, and hydraulic, pneumatic, and electrical tools.
Estimate sizes, distances, quantities, time, costs, resources, or materials needed to perform work activities.
Inspect subordinate work for compliance with contract plans and specifications; identify deficiencies, explain them, and take corrective action.
Observe and comply with safety and project rules and perform other duties as required.