Mechanic 3

Bakery Feeds, by Darling Ingredients•Rose Hill, NC

6d•Onsite

About The Position

The Maintenance Mechanic 3 performs preventive and corrective maintenance in a plant under management supervision. The role supports equipment installation and fabrication and construction projects, maintains process machinery and hydraulic equipment, and helps train Level 1 and 2 Maintenance personnel. The position is based in a rendering facility and may require travel to other plants for construction projects. Nights and weekends may be required, and the employee must be available on call as needed.

Requirements

High school diploma or GED.
At least 6 years of experience with rendering or similar equipment.
Advanced welding, piping, and fabrication skills.
Ability to pass a skills test on a 480V combination starter/breaker box and its control voltage.
Frequently push, pull, move, or lift up to 100 pounds.
Frequently walk, stand, climb, balance, stoop, kneel, crawl, and crouch; regularly reach with hands and arms.
May need to travel to other plants for construction projects.
May need to work nights and weekends and be available on call as needed.
Tolerate wet and/or slippery floors and high heat or cold temperatures in a rendering facility.

Nice To Haves

Vocational school training.
Basic knowledge of general maintenance and equipment operations.
General mechanical aptitude, including ability to diagnose problems with motors and other equipment.
Good math skills, including adding, subtracting, multiplying, and dividing whole numbers, fractions, and decimals.
Demonstrated advanced welding skills.

Responsibilities

Assist with installation of new equipment.
Assist the Maintenance Supervisor and/or other personnel with special fabrication and construction projects.
Follow the preventive maintenance schedule.
Train Level 1 and 2 Maintenance personnel.
Troubleshoot and repair process machinery and hydraulic equipment.
Change electrical breakers and electrical starters, and operate voltage, amp, and ohm meters.
Maintain a clean, neat, and orderly work area.
Use assigned safety equipment, including a bump cap, safety glasses or goggles, welding protection, and a safety harness; know and observe Company safety rules and regulations.
Attend regularly scheduled safety meetings and potentially serve on the Safety Committee.
Perform other duties as assigned.