Maintenance Generalist - Night Shift - RVI Forest, MS

Tyson Foods•Forest, MS

2d•Onsite

About The Position

This position is responsible for general maintenance throughout the plant while adhering to Tyson policies and procedures. The role works the night shift from 7 p.m. to 7 a.m., with maintenance hourly employees rotating workdays every four weeks. The employee may perform various positions as assigned and may monitor the boiler and perform chemical tests on it. The position involves maintaining and promoting Tyson’s safety culture and receiving training as required.

Requirements

At least 1 year of maintenance or mechanical experience.
At least 6 months of continuous employment within the last 2 years.
At least 1 year of experience in welding and industrial maintenance.
Basic mechanical or maintenance skills and knowledge of welding, hydraulics, basic electricity, power transmission, pneumatics, and plumbing.
Ability to use basic hand tools and various electrical and pneumatic power tools and equipment.
Ability to read and understand assignments and communicate orally and in writing.
Ability to hear and respond to a two-way radio.
Ability to lift 50 pounds, climb stairs and ladders up to 60 feet, and stand for long periods.
Ability to withstand extreme hot and cold conditions, inclement weather, and odors.
Basic math knowledge.
Certification to operate various gas- or hydraulic-powered motors and lifts.
Ability and willingness to perform the physical requirements of the job, with or without reasonable accommodation.

Nice To Haves

Respirator-qualified.

Responsibilities

Maintain and promote the Tyson safety culture.
Perform general maintenance throughout the plant while following company policies and procedures.
Perform assigned positions and other duties as directed by the supervisor.
Perform welding and cutting, minor electrical repairs, and removal or replacement of motor shafts, couplings, pumps, augers, water and steam pipes, lines, and systems.
Monitor the boiler and perform chemical tests on it as needed.
Read drawings and schematics for hydraulic and basic electrical systems when required.
Receive required training and pursue further education through outside training, company testing programs, and vendor training.