Inspector - 1st Shift

Eaton Corporation • Waukesha, WI

3d • Onsite

About The Position

The Inspector C performs assembly inspections of transformers/regulators at various locations in the assembly plants per established procedures. Perform electrical testing on assembled single and three-phase transformers/regulators per established procedures. Monitor conformance to quality standards.

Requirements

• High school graduate or GED equivalent from an accredited institution.
• Minimum of (1) One year of manufacturing experience.
• Must be able to work in the United States without corporate sponsorship now and in the future.
• No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of the work location will be considered. Active-duty military Service member candidates are exempt from the geographical area limitation.
• Ability to work overtime when required.
• Ability to interpret prints and applicable engineering and quality specifications.
• Ability to meet or exceed quality and productivity standards.
• Demonstrated effective communication with team and supervisor.
• Ability to lift up to 50 LBS; bend, twist, grab, reach, stand, walk, push, pull, use both hands to lift and lower materials, and perform all other essential duties with or without reasonable accommodations.

Nice To Haves

• Education in AC/DC fundamentals, or equivalent knowledge of electrical prints / schematics (minimum of 1 year)
• Previous experience in electrical inspection / troubleshooting, or equivalent experience in electronics or electrical assembly, HVAC, or variable frequency drive assembly.
• Minimum of one year of transformer or electronics and electrical testing experience.

Responsibilities

• Perform the following tests as required per established procedures but not limited to: ratio (variety), resistance (variety), continuity, VFI, CT, and hipot (applied potential), OX (induced), impulse, power factor, load loss, and core loss
• Inspection of unit nameplates, stamp impedance value on nameplates, and secure nameplates to tested units.
• Perform visual inspection of units throughout the assembly process per established procedures; including but not limited to: Inspection of core/coil, interior of unit, paint millage, exterior of unit, and decal/stencil placement.
• Complete weekly oil sample tests.
• Perform minor maintenance of test equipment.
• Perform special routine tests when required.
• Assisting Engineering and Manufacturing in identifying and resolving shop floor problems.
• Completing various company forms to communicate inspection status and other information and to document inspection results per established procedures.
• Collecting various types of data per established procedures as require.
• Understand and follow the EQMS policies.

Benefits

• Health benefits and vacation time - available to use on day one of your employment!
• Paid holidays - up to 12!
• Weekly pay
• Shift premiums - $2.50/hr for off shifts & Opportunities for overtime.
• Career progression opportunities to cross-train in different departments and increase compensation.
• Retirement benefits, Paid Parental Leave, Educational Assistance Program, Wellness Reimbursement, and more!

What This Job Offers

• Job Type: Full-time
• Career Level: Mid Level
• Education Level: High school or GED