Inspector, 1st Class

Curtiss-Wright Corporation•East Farmingdale, NY

1d•Onsite

About The Position

Target Rock is seeking a 1st Class Inspector to inspect raw materials, in-process machined parts, and finished-machined parts for compliance with engineering drawings and company specifications before assembly into finished products. Inspections include in-process checks; first-piece inspections to qualify a new setup and process; and inspections of forged or cast pieces to qualify dies and processes. The Inspector determines the quality and conformance of machined parts and performs inspections using a CMM or conventional methods. The position is located in East Farmingdale, New York, and pays $32.07 per hour. The role may require exposure to export-controlled information and additional security screening.

Requirements

High school or trade school graduate at minimum.
Must be a U.S. citizen.
Expert knowledge of engineering blueprint and specification reading in accordance with ASME Y14.5.
Extensive knowledge of measuring tools.
Ability to measure thread features using System 21 or 22.
Ability to interpret and measure geometric features per ANSI Y14.5.
Ability to calibrate and set thread gauges, including Johnson Thread gauges, and use an optical projector.
Must pass Target Rock's visual acuity test.
Sufficient manual dexterity to handle and manipulate delicate parts and measuring instruments.
Ability to verify material hardness and detect material cracks, pinholes, or other defects.
Ability to verify material traceability and accountability by reviewing approved material certification.
Ability to lift up to 40 pounds when required for inspection and parts handling.

Responsibilities

Interpret engineering drawings and specifications and apply the relevant standards during inspection.
Determine inspection procedures to verify specifications and dimensions completely.
Calibrate and/or verify the accuracy of basic inspection tools, including thread gauges, micrometers, and functional gauges.
Select appropriate measuring tools independently to inspect parts for compliance with specifications.
Evaluate out-of-specification items for possible salvage and recommend rework where applicable.
Assist in training other inspectors to perform calibration and use optical comparators, hardness testers, and other inspection tools.
Complete required company paperwork to process jobs, including C1 documentation, Method 1 and Method 2, Commercial Grade documentation, inspection records, and inspection reports, as applicable.
Pass the First Class Dimensional Inspection Test.
Perform additional responsibilities as assigned by the Supervisor.