Industrial Controls Panel Builder / Electrical Installer
About The Position
The Industrial Controls Panel Builder / Electrical Installer assembles, wires, installs, and provides start-up support for industrial control systems, including PLC panels, motor control centers (MCCs), low- and medium-voltage switchgear, and instrumentation systems. The position is primarily focused on shop fabrication, with field installation support as needed. Work must be completed safely, accurately, and in accordance with project specifications, drawings, and company standards. This is a temp-to-hire position in Houston, Texas. The stated schedule is 7 a.m. to 4 p.m., Monday through Friday. Pay is $25–$35 per hour, depending on experience, and the start is ASAP.
Requirements
- High school diploma or equivalent.
- 2–5+ years of experience in industrial electrical controls and panel building.
- Ability to read and interpret electrical drawings and schematics.
- Experience with tools and equipment used for panel building and electrical installation.
- Ability to work in shop and industrial field environments, including indoor and outdoor conditions.
- Ability to lift up to 50 pounds and perform tasks requiring bending, climbing, and standing for extended periods.
- Ability to travel to job sites if requested.
- Strong attention to detail and commitment to quality.
- Ability to work independently and as part of a team.
- Strong troubleshooting and problem-solving skills.
- Willingness to work overtime and flexible schedules to support project demands.
Responsibilities
- Assemble industrial control panels, PLC panels, junction boxes, MCC sections, and switchgear according to electrical schematics and layout drawings.
- Perform point-to-point wiring of control devices, including relays, terminal blocks, PLC I/O, VFDs, breakers, and instrumentation.
- Fabricate and install panel components such as DIN rail, wire duct, bus bar systems, and mounting hardware.
- Label and tag devices, wires, and components according to project standards.
- Check wiring accuracy, torque requirements, and workmanship.
- Assist with panel factory acceptance testing (FAT) and documentation.
- Install control panels, MCCs, and associated equipment at industrial facilities.
- Run conduit, cable tray, and supports; pull and route power and control cables.
- Terminate power, control, and instrumentation cables, including low- and medium-voltage cables where applicable.
- Install and connect transmitters, sensors, motors, and control valves.
- Ground panels and equipment according to applicable standards.
- Support loop checks, point-to-point verification, and system checkout.
- Operate a forklift.
- Travel to job sites if requested.
- Work overtime and flexible schedules to support project demands.
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
