Electrician (Maint - Systex, 2nd shift)

Denso•Battle Creek, MI

3d•Onsite

About The Position

This position is for a Journeyperson Electrician in the DMMI Maintenance department, specifically for Molding / Systex Products Corporation (SPC), Dept. 260. The role is primarily onsite at Systex (SPC) with potential rotation to DMMI. The core working hours are from 3:00 PM to 11:30 PM. A resume is required for consideration. Associates must meet approximately 75% of the job requirements at the time of bid and demonstrate the ability to meet the full scope of job requirements within one year.

Requirements

High School diploma or G.E.D. equivalent.
Must be a Machine Repair or Electrician Journeyperson (as recognized by the Department of Labor) or have 5 years equivalent machine repair or electrician experience working with a recognized Machine Repair or Electrician Journeyperson.
Review of safety hazards unique to the position.
Be able to go online with HMI/PLC, Servos, and Robots.
Basic programming / Editing for HMI/PLC.
Upload / Download for HMI/PLC, Servos, and Robots.
Troubleshooting / Search for HMI/PLC, Servos, and Robots.
Create program backups for HMI/PLC.
Perform motor and cable replacements on robots.
Perform controller replacement on robots.
Climb out on robots to repair using a 5-point harness.
Experience with Injection molding machines.
Experience with N2 testers, Function testers, Motor press, and Fan balance.
Must understand DMMI lifting procedures.
More than 2 years in current position unless promotable (length of service for journeypersons is based on apprenticeship entry date).
Last Performance Appraisal Meets or Better.
No Active Written Discipline.
Must be able to perform the essential functions of the position.

Responsibilities

Perform preventative maintenance, repair, replace, or rebuild items as listed in the requirements.
Go online with HMI/PLC, Servos, and Robots.
Perform basic programming/editing, upload/download, and troubleshooting for HMI/PLC.
Troubleshoot/search for HMI/PLC programs and create program backups.
Upload/download and troubleshoot/search for Servos.
Upload/download and troubleshoot/search for Robots.
Perform motor and cable replacements on robots.
Perform controller replacement on robots.
Climb out on robots to repair using a 5-point harness.
Work with Injection molding machines.
Operate N2 testers, function testers, motor press, and fan balance equipment.
Understand DMMI lifting procedures for rigging.