Electrical Engineering Intern (Summer 2027)(Onsite)

RTX•Goleta, CA

3d•$42,000 - $88,000•Onsite

About The Position

As a 2027 intern on the Electrical Engineering team at Raytheon Vision in Goleta, California you will collaborate with team members in the development of electronic products while meeting attendant size, weight, power, reliability, and cost requirements. You will be teamed with more senior engineers on potentially any of the following: digital / analog hardware architecture, schematic capture, design analysis, simulation, parts selection, and hands-on laboratory validation and troubleshooting of complex electronic assemblies and systems.

Requirements

Must be pursuing a Bachelor’s or Advanced degree in Electrical Engineering and actively enrolled through completion of the internship / co-op session.
Must have a minimum of 60 hours of credit by the start of the internship / co-op session.
Coursework, laboratory experience, or project experience in Circuit Design & Analysis is required
Experience or coursework using tools such as MATLAB, SPICE, and Circuit Board design software.
Experience may be obtained through on-the-job experience, research, coursework, or projects.

Nice To Haves

Experience or coursework in any of the following areas:
Electrical design and analysis with Circuit Board design tools (such as Altium or Mentor Graphics XPedition and HyperLynx SI, and SPICE
Design of CCAs with FPGAs, flash memory, DDR RAM, ADCs, DACs, power conversion integrated circuits, and supporting analog circuits
Power electronics, motor controls, RF systems, or mixed-signal circuit design
FPGA-based circuitry and JTAG programming of FPGA devices
Microcontroller programming, signal integrity analysis

Responsibilities

Support design and develop high speed digital hardware for Raytheon Vision Systems (RVS) aerospace and aeronautical imaging products and supporting test equipment for those products.
Participate to use standard design and layout tools to develop schematics, participate circuit card layout, and participate circuit analysis of hardware that is developed for those projects.
Support and participate in a cross-function team of mechanical engineers, test engineers, firmware engineers, systems engineers, and manufacturing engineering to develop challenging electronics design hardware solutions for RVS imaging products.