Die Cast Set-Up Operator

Kurt Manufacturing•Fridley, MN

About The Position

The Die Cast Set-Up Operator sets up and operates die casting machines that cast parts from nonferrous metals, such as aluminum. The schedule is 3:00 p.m. to 1:30 a.m., Monday through Thursday. The anticipated hourly starting rate is $21.26 to $28.00; the exact rate may depend on the candidate’s knowledge, experience, skills, abilities, and education. Reliable attendance is required. Duties and responsibilities may change at any time and are not limited to those listed.

Requirements

High school diploma or equivalent GED.
One month of related experience.

Nice To Haves

Six months of related experience.
NADCA Level I Certification.

Responsibilities

Lift specified die sections into the machine using a chain or hoist, bolt them in position, and adjust the ram stroke using hand tools.
Connect water hoses to the die cooling system and preheat die sections using a torch or electric heater.
Set valves and dials to regulate water flow, cycle timing, and machine operating speed based on the part and metal being cast.
Set up robotic operations.
Start the machine to produce a sample casting and examine it to verify the setup.
Blow metal fragments from die surfaces using an air hose and spray lubricant over the die cavity and plunger.
Operate the machine to close and lock dies and force molten metal into die cavities; remove castings with tongs or pliers.
Inspect castings for defects such as cracks or blisters and make process or equipment adjustments as necessary.
Measure castings using fixed gauges, as needed.
Perform maintenance, clean equipment, adjust malfunctioning machines, and clean furnaces, as needed.
Operate a gas- or electric-powered forklift to move, stack, or unload metal in the facility, as needed.
Count, weigh, or record the number of units of metal moved or handled.