CNC Router Operator

Ethan Allen•Maiden, NC

About The Position

Operate a CNC router to process plywood sheets. Prepare and inspect plywood and milling boards, load and initiate work orders using the router’s touch screen, handle cut parts and scrap, clean the work area and equipment, and restock plywood using a forklift. May perform other duties or special or non-routine assignments as instructed.

Requirements

Ability to read and follow verbal and written directions.
May require basic math skills, including counting, adding, and subtracting.
Ability to lift up to 50 pounds.

Nice To Haves

Previous experience preferred.

Responsibilities

Use a suction lift to move plywood sheets to the milling board on the table for inspection and preparation before loading the router.
Slide the plywood sheet and milling board from the roller table to the router and fit them into place.
Load or select the work order on the touch screen and initiate the cut.
Pull cut parts and stack them on a frame buggy.
Break up plywood scrap and place it in a scrap buggy.
Sweep the floor around the work area and CNC machine.
Push the frame buggy into position and take the scrap buggy to the grinder conveyor when it is half full, then dump the scraps.
Roll the milling board through the vacuum system to remove dust, then return it to the inspection and loading table.
Clean the router table with an air-restricted blow gun and/or vacuum to remove excess dust.
Use a forklift to restock plywood by moving a 35-sheet stack from stock to the router.
Perform weekly cleanup by hitting the emergency stop switch, climbing onto the machine, and wiping it down.
Perform other duties or special or non-routine assignments as instructed.