CAL TECH 3

Huntington Ingalls•Newport News, VA

6d•$62,000 - $80,000•Onsite

About The Position

The Cal Tech 3 calibrates electronic test measuring and signal-generating equipment to meet established standards. The role tests, calibrates, adjusts, and maintains electromechanical, mechanical, optical, pneumatic, hydro-mechanical, and pressure-type measuring and indicating instruments. It sets up calibration sequences, methods, and procedures according to detailed specifications, blueprints, drawings, and requirements. The position also disassembles, cleans, repairs, and replaces defective parts in test equipment such as pressure gauges and tension meters, and may monitor and verify quality in accordance with statistical process or other control procedures. This is a full-time, first-shift position at Newport News Shipbuilding. U.S. citizenship and an interim clearance are required to start. Telework is not available, travel is not required, and relocation assistance is not available. The stated salary range is $62,000 to $80,000.

Requirements

Associate's degree and 3 years of relevant experience, or an accepted equivalent qualification.
Accepted equivalents to the associate's degree requirement include: NNS Apprentice School graduate; Navy Nuclear Power School (NNPS) graduate; high school/GED and 2 years of related manufacturing, shipbuilding, trades, or military experience; or high school/GED and 4 years of non-related manufacturing, shipbuilding, trades, or military experience.
Basic electronics knowledge.
Knowledge of how to use test equipment, including multimeters, signal generators, and scopemeters.
Ability to follow written procedures.
U.S. citizenship is required.
Interim clearance is required to start.

Nice To Haves

Ability to read electronic schematics.
Component-level circuit testing experience.
Prior calibration-level experience.

Responsibilities

Calibrate electronic test measuring equipment and signal-generating equipment to conform to established standards.
Test, calibrate, adjust, and maintain electromechanical, mechanical, optical, pneumatic, hydro-mechanical, and pressure-type measuring and indicating instruments.
Set up calibration sequences, methods, and procedures according to detailed specifications, blueprints, drawings, and requirements.
Disassemble, clean, repair, and replace defective parts of test equipment, including pressure gauges and tension meters.
May monitor and verify quality in accordance with statistical process or other control procedures.