Day shift welder

Drake-Williams Steel•Omaha, NE

About The Position

The Welder fabricates structural, plate, and miscellaneous steel assemblies according to shop drawings, weld procedures, weld symbols, quality requirements, and applicable AISC requirements. The role involves identifying steel shapes and tolerances, welding and preparing work pieces, fabricating sub-pieces, and identifying drawing errors or discrepancies. The employee also moves materials with shop lifting equipment and performs other duties as assigned. The position is expected to work 40 hours per week; overtime and weekends may be required based on business needs.

Requirements

  • High school degree or equivalent.
  • At least six months of experience as a welder for a steel fabricator or manufacturer, or a one-year welding technology degree or certificate from a qualified trade school or college.
  • Ability to read, write, and perform arithmetic computations involving whole numbers, decimals, and fractions.
  • Ability to understand and carry out semi-complicated verbal and written instructions and communicate effectively with coworkers and managers.
  • Ability to work under periodic supervision focused on work progress and priorities.
  • Skill using a tape measure or 1 rule.
  • Ability to maintain American Welding Society certification on 1-inch plate in the flat position using gas metal arc welding and flux cored arc welding processes.
  • Ability to pass a fillet weld break test using the gas metal arc welding process.
  • Ability to pass the employer-administered welding test covering shop drawing interpretation, weld symbols, welding processes, process symbol interpretation and application, and visual acuity.
  • Ability to pass the employer-administered fitting test covering shop drawing interpretation, fractional calculations, and basic geometry.
  • Ability to interpret and use cutting lists, shop orders, and shop drawings.
  • Ability to operate a cutting torch to American Welding Society specifications.
  • Demonstrated pride in workmanship, attention to detail, and safe work practices.
  • Ability to safely operate forklifts, jib hoists, and overhead cranes and use relevant crane hand signals.
  • Ability to adjust a welder for proper feed rate and temperature and to multitask.
  • Ability to meet the physical demands of the role, including standing and walking continuously during an 8- to 12-hour shift, lifting and carrying specified weights, occasional climbing, stooping, crouching, kneeling, reaching, and balancing, and occasional or rare crawling.
  • Sufficient hearing to be aware of safety issues and vision to read and interpret cut lists and shop drawings.
  • Wear required PPE, including steel-toe safety shoes, hearing protection, safety glasses, gloves, and hard hats.

Responsibilities

  • Identify steel shapes, sizes, and mill tolerances.
  • Weld structural, plate, and miscellaneous steel fabrications according to weld symbols, procedures, shop drawing dimensions, and AISC code requirements.
  • Preheat and/or cut work pieces using a hand torch when required.
  • Clean welds of excess weld, splatter, and slag using chipping hammers, wire brushes, or grinders.
  • Fabricate sub-pieces of assemblies as trained and instructed.
  • Identify shop drawing errors and discrepancies before or during early fabrication.
  • Operate forklifts, jib cranes, and overhead cranes to move materials.
  • Attend meetings as required by management and perform other duties assigned by management.
  • Work scheduled hours consistently and reliably at assigned locations.
  • Follow shop safety requirements, wear required PPE, and use crane hand signals appropriately.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service