Day shift welder

Drake-Williams Steel•Omaha, NE
•$19 - $30•Onsite

About The Position

The Welder fabricates structural, plate, and miscellaneous steel assemblies according to shop drawings and Drake-Williams Steel quality requirements. The role involves identifying steel shapes, sizes, and mill tolerances; interpreting weld symbols and procedures; and meeting applicable AISC code requirements. Welders may also preheat or cut workpieces with a hand torch, clean welds, fabricate sub-pieces, and identify drawing errors or discrepancies. The position requires safe operation of material-handling equipment and consistent attendance at assigned locations and scheduled hours. Work is performed in a shop environment with occasional exposure to heat, cold, wet and humid conditions, fumes, odors, dust, solvents, greases, oils, and coolants. Personal protective equipment is required.

Requirements

  • High school degree or equivalent.
  • At least six months of experience as a welder for a steel fabricator or manufacturer, or a one-year welding technology degree or certificate from a qualified trade school or college.
  • Ability to read, write, and perform arithmetic involving whole numbers, decimals, and fractions.
  • Ability to understand and carry out semi-complicated verbal and written instructions and communicate effectively with coworkers and managers.
  • Ability to work under periodic supervision focused on work progress and priorities.
  • Skill using a tape measure or 1 rule.
  • Ability to maintain American Welding Society certification on 1-inch plate in the flat position using gas metal arc welding and flux cored arc welding processes.
  • Ability to pass a fillet weld break test using the gas metal arc welding process.
  • Ability to pass company-administered welding and fitting tests, including shop-drawing interpretation, weld symbols and processes, fractional calculations, basic geometry, and visual acuity.
  • Ability to interpret and use cutting lists, shop orders, and shop drawings.
  • Ability to operate a cutting torch to American Welding Society specifications.
  • Attention to detail, pride in workmanship, safe work practices, and ability to multitask.
  • Ability to safely operate forklifts, jib hoists, and overhead cranes and use crane hand signals.
  • Ability to meet the physical demands of the job, including prolonged standing and walking, lifting and carrying materials, climbing, stooping, crouching, kneeling, reaching, and occasional crawling.
  • Sufficient hearing to be aware of safety issues and visual ability to read and interpret cut lists and shop drawings.
  • Expected to work 40 hours per week; overtime and weekends may be required based on company needs.

Responsibilities

  • Identify steel shapes, sizes, and mill tolerances.
  • Weld structural, plate, and miscellaneous steel fabrications according to weld symbols, procedures, shop-drawing dimensions, and AISC code requirements.
  • Preheat and/or cut workpieces with a hand torch when required.
  • Clean welds of excess weld material, splatter, and slag using chipping hammers, wire brushes, or grinders.
  • Fabricate sub-pieces of assemblies as trained and instructed.
  • Identify shop-drawing errors and discrepancies before or during early fabrication.
  • Operate forklifts, jib cranes, and overhead cranes to move materials.
  • Attend meetings as required by management and perform other duties assigned by management.
  • Work scheduled hours consistently and reliably at assigned locations.
  • Adjust welding equipment to ensure proper feed rate and temperature.
  • Use industry and company-adopted crane hand signals and operate equipment safely.
  • Wear all required personal protective equipment.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service