UNDERCARRIAGE SPECIALIST I

Gregory Poole•Hope Mills, NC

2d•Onsite

About The Position

The purpose of this position is to rebuild track rollers, load tracks onto the track rebuilding “bench”, dismantle & rebuild track links. This role involves checking equipment and supplies, complying with PPE requirements, and preparing for duties. The specialist will use various equipment like forklifts and hoists to move and assemble/disassemble parts of tracks and rollers. This includes replacing worn parts, bushings, and bearings, and reattaching track pads.

Requirements

Must have a high school education or GED
Requires up to two years schooling or direct work experience
Must be mechanically inclined
Must have good basic knowledge obtained through schooling or work experience
Must be able to daily and repeatedly stoop, kneel, bend and climb onto and underneath various equipment to perform diagnosis and repairs
Must be able to effectively see to perform repairs, research technical manuals, and develop written repair work order reports
Must be able to routinely and physically lift/position various parts to perform repairs/service and manually handle parts up to 80 pounds, as well as use mechanical hoist for heavier parts
Must be able to effectively write repair activities on customer work orders
Must have cognitive reasoning and problem-solving skills to apply knowledge, written information and verbal instructions in repairing/servicing unusual and/or unknown technical equipment operational problems
Should have exposure to P.C. base equipment and parts information
Capable of learning and understanding technical information, service manuals and reports

Responsibilities

Rebuild track rollers
Load tracks onto the track rebuilding bench
Dismantle and rebuild track links
Check equipment and supplies required to perform the work scheduled
Comply with PPE requirements
Use forklift to move pallets loaded with rollers
Use hoist to lift rollers onto the worktable
Replace worn parts of rollers
Use forklift to move tracks and load them onto the track rebuilding bench
Unbolt tracks
Use cable to pull links to the pin driver mechanism
Lift links to the rebuild bench
Replace bushings
Reassemble track
Use material movers to move pallets of track rollers to the rebuilding station
Use special hoist to lift rollers onto the rebuild bench
Use tools to dismantle the rollers and replace worn parts
Use mauls/drivers to remove pins from tracks
Use forklift to remove track from vehicle and move the track to the track rebuilding bench
Assist in performing pin and bushing turns using press tooling
Use rebuilding equipment to pull track onto the repair bench
Use hand/power tools to remove fasteners that hold the track pads to the links
Attach a cable to the links and pull the links to the link disassembly equipment
Use the link disassembly equipment to separate links
Lift the links to the building table
Replace bearings in the links
Lift the links back onto the link disassembly equipment and reassemble the links
Reattach the pads
Reinstall the track
Effectively write repair activities on customer work orders