Tester II - 2nd Shift

Eaton Corporation•Irvine, CA

15h•Onsite

About The Position

Eaton’s Aerospace Fuel, Motion, & Controls division is currently seeking a Tester II - 2nd Shift to join our team at our Irvine, California site. The hourly rate for this position is $25.00 plus a $1/ hour shift differential per hour. The hours for this shift are 2pm - 10:30pm Monday - Friday. Overtime may extend these hours, and weekend availability is heavily preferred for overtime. This position is also eligible for a variable incentive program. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

Requirements

High School Diploma or GED from an accredited institution is required
Minimum of three (3) years’ work experience in Fuel, Hydraulic and/or Pneumatic Testing is required
Candidates must reside within 50 miles of Irvine, CA in order to be considered. Active Duty Military Service member candidates are exempt from the geographical area limitation.
This position requires use of information which is subject to the International Traffic in Arms Regulations (ITAR). All accepted applications must be U.S. Persons as defined by ITAR (U.S. citizen, U.S. Permanent Resident, Political Asylee, or Refugee).
Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers
Ability to use direct reading and fixed gauges
Able to read blueprints and schematics
Detailed Oriented
Works Independently
Continuous Improvement
Follow Safety Practices & Procedures
Ability to lift up to 50lbs

Nice To Haves

Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries

Responsibilities

Perform bench testing of a diversified line of parts, subassemblies and completed units following established procedures.
Perform bench work requiring use of simple limit direct reading gauges and meters
Build / fabricate own setup operations on less complicated test systems
Connect products to be tested to test equipment, monitor gauges and meters, verify and record results
Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals. Keep assigned work-area clean, organized, and orderly per 5S standards.
Perform Lean Initiatives including Continuous Improvement
Lead and interpret blueprints & schematics