Tester II - 1st Shift
About The Position
The Tester is responsible for performing bench testing of a diversified line of parts, subassemblies and completed units following established procedures. In this function you will: Perform bench work requiring use of simple limit direct reading gauges and meters. Build / fabricate own setup operations on less complicated test systems. Connect products to be tested to test equipment, monitor gauges and meters, verify and record results. Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals. Keep assigned work-area clean, organized, and orderly per 5S standards. Perform Lean Initiatives including Continuous Improvement. Lead and interpret blueprints & schematics.
Requirements
- High School Diploma or GED from an accredited institution is required
- Minimum of three (3) years’ work experience in Fuel, Hydraulic and/or Pneumatic Testing is required
- Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers
- Ability to use direct reading and fixed gauges
- Able to read blueprints and schematics
- Detailed Oriented
- Works Independently
- Continuous Improvement
- Follow Safety Practices & Procedures
- Ability to lift up to 50lbs
- Must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
Nice To Haves
- Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries
Responsibilities
- Perform bench work requiring use of simple limit direct reading gauges and meters
- Build / fabricate own setup operations on less complicated test systems
- Connect products to be tested to test equipment, monitor gauges and meters, verify and record results
- Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner
- Understand and meet all departmental safety objectives and goals
- Keep assigned work-area clean, organized, and orderly per 5S standards
- Perform Lean Initiatives including Continuous Improvement
- Lead and interpret blueprints & schematics
Benefits
- Health and Welfare benefits
- Retirement benefits
- Paid and unpaid time away from work
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
