Sheet Metal Fabricator

Tennant Company•Golden Valley, MN

4d•$21 - $32•Onsite

About The Position

The Intermediate Sheet Metal Fabricator is responsible for the safe set up and operation of manual sheet metal machines to achieve established quality and efficiency standards. Working within a team, you’ll create quality parts that go into Tennant products. If you self-driven, enjoy use your problem solving then this is the role for you.

Requirements

High school diploma or equivalent
Technical degree and 2 or more years of related Sheet Metal Fabrication experience or 5 or more years of Sheet Metal Fabrication experience
Previous press brake operating experience is required.
Must be able to obtain a forklift license through Tennant Co
Must be legally authorized to work in the United States without sponsorship

Nice To Haves

Prefer Cincinnati experience
Two years general sheet metal training or two years vocational training in sheet metal or related field preferred

Responsibilities

Set up and operate Cincinnati CNC press brakes, CNC Mazak, Trumpf, and/or Amada lasers
Run manual sheet metal machines
Operate additional machines or process steps internal to primary to machine cycle times
Perform cutting and/or shaping metal from raw form into usable parts for Assembly or Aftermarket needs
Utilize equipment and measurement tools to drive part accuracy within print tolerances and minimize Quality Notifications and Scrap
Process may be non-descript or variable, requiring changeovers/setup, troubleshooting, and adjustment to complete assigned tasks
Adept at performing 2 or more processes proficiently within the department
Assist other operators in understanding quality expectations
Act as an agent of change on the shop floor by influencing peers