Service Engineer

Exyte GmbH•Boise, TX

5d•Onsite

About The Position

The Service Engineer is a key position in the Facility Services (FAS) team and is based at a customer facility located in Boise, ID. The Service Engineer is responsible for accepting, maintaining & optimizing equipment throughout it’s entire lifespan. This includes, but is not limited too, equipment installation, commissioning, acceptance, start-up and then into sustaining operations, retrofits and ultimately decommissioning and demobilization. The Service Engineer will collaborate with equipment OEM, internal operations teams and key client stakeholders to ensure safety, accurate operations of the equipment.

Requirements

Trade school qualification, associate degree, or higher
Ideally at least 3 years experience in the Semiconductor industry, or an equivalent role in a relatable industry
Electrical / Electronics / Mechanical / Plumbing / Gas / Chemicals / Facility Management
Use of basic hand tools, power tools and diagnostic equipment
Ability to work effectively in a team environment
Ability to use Microsoft programs such as Word and Excel
Ability to Multitask
Applicants must be authorized to work for ANY employer in the U.S. We are unable to sponsor or take over sponsorship of an employment Visa at this time.

Responsibilities

Compliance with customer Equipment Acceptance & Lifecycle protocol and achieving signoff with customer EH&S department and tool owner
Technical SOP development and training towards Exentec operations team & client (where required)
Setpoint and other controller variable management (e.g., alarm setpoints, conditions, delays, and responses) and processing of Management of Change requests, as applicable
System fault-finding, resolution, and evaluation of learnings for cross system implementation
System optimization and recommendation / implementation of improvement and upgrading projects
Participate in troubleshooting baseline reliability issues, and continually work to improve system uptime
Adhere to the company’s safety regulations as well as the customer’s site regulations and follow all the guidelines
System ‘Finger printing’ to ensure all critical setpoints are checked and maintained
Retrofit and modifications projects
Software upload / download / backup
I/O interface wiring, testing & verification
Component 2nd sourcing strategy
Input to maintenance planning and execution
Red lining of P&ID, Specification, and procedures
Job Hazard Analysis preparation and verification
Best practice sharing and implementation
Other duties as assigned