Seals Operator - 3rd Shift

Eaton Corporation•Calverton, MD

20h•Onsite

About The Position

Eaton’s IS AER FED division is currently seeking a Seals Operator - 3rd Shift to join our team in Beltsville, MD! The core hours are 11 pm - 7 am. The hourly rate for this position is $22.00 per hour + 10% shift premium. Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

Requirements

High School Diploma or equivalent (GED) from an accredited institution.
Minimum of 1 year of work experience.
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
No relocation benefit is offered for this position. Only candidates within a 50-mile radius of the work location will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation.
This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee.
Safety first focus factory which requires proper PPE where applicable.
Ability to lift up to 35 pounds with or without reasaonable accommodation.
Ability to stand on your feet anywhere from up to 10 hours per day with or without reasonable accommodation.
Ability to focus evaluations from close proximity and frequent use of hand to eye coordination.

Responsibilities

Log-on to the computer and scan work order
Read process sheet and blueprint for the work order.
Set-up the seal machines in the cell, by adding tooling to the machines.
Process parts through machining
Measure seals using tools such as micrometers, pi tape, gauge, venires, etc. by checking dimensions as indicated on the blueprints.
Document and control dimension using the SPC (statistically process control)
Participate in lean and 5S+ activities, as required.
Complete and maintain production line logs
Perform other related duties as assigned.