Saw

Leggett & Platt•Fort Worth, TX

5d•Onsite

About The Position

This position is responsible for operating cutting equipment, maintaining cut lists, pulling roll stock, loading and unloading rolls, organizing inventory, and bagging cut samples according to quality standards. The role also involves performing quality checks, assisting with equipment maintenance, and other job functions as directed by the supervisor. Safety and environmental compliance are key aspects of this role.

Requirements

Be able to read, write, and count correctly
Basic Math, English, use a tape measure, weight scale, and micrometer
Be able to follow both written and verbal work instruction
Have good communication skills
Be detail oriented
Be able to change tasks, prioritize, and re-prioritize frequently and able to follow-up on work tasks as needed in a timely manner
Be able to bend, twist, push, pull, and lift (Up to 50lbs; anything heavier than that should be a two-person lift)
Wear proper Personal Protection Equipment (PPE) when applicable
Must work in an uncontrolled temperature environment
Operate a pallet jack

Responsibilities

Operate cutting equipment: Band saw, rotating knife saw and die press
Cut material to standard sample size; adjust as required
Maintain cut list schedule to sample inventory stock
Pull roll stock per the schedule
Load and Unload rolls as needed
Maintain organization of roll stock and shelves
Bagging cut samples properly following quality checks and requirements
Stocking sample inventory
Cut material into samples to keep shelves stocked
Responsible for communicating and assisting in the preventive and predictive maintenance of saw equipment
Perform other job functions as directed by supervisor
Quality check
Assist Sample Clerk’s when needed
Adhere to material cut standards
Review material after first cuts to inspect for quality of material
Must commit to creating a culture where partners are protecting partners- “You See Something, Say Something!”
Comply with all company policies and procedures listed in the Leggett & Platt Employee Handbook
Report all incidents, accidents, and near-misses to your supervisor immediately
Assist in recognizing, responding, reporting, and eliminating hazards and assuring safety compliance
Participate in: On-the- Job (OJT) Training documentation, Use of CAR/PARs (Corrective / Preventative Actions), Incident/Accident/Near-Miss Investigations to determine root cause, Use of required PPE, Participation in training events, Good housekeeping in the work area and entire company grounds
Understand and commit to: No personal cell phone use on the production floor; Active cell phone use does not go beyond breaks and lunches, No horseplay, yelling, or violence in the workplace, No eating or open drinks are allowed on the production floor
Commit to environmental preservation through: Stormwater Pollution Prevention, Participation in recycling initiatives, Proper use of waste containers, Participation in training events