Saw

Leggett & Platt•Fort Worth, TX

3d•Onsite

About The Position

This position is responsible for operating cutting equipment such as band saws, rotating knife saws, and die presses to cut material to standard sample sizes. The role involves adjusting cuts as required, maintaining a cut list schedule to ensure adequate sample inventory, and managing the loading and unloading of rolls. Additionally, the position requires maintaining organization of roll stock and shelves, properly bagging cut samples after quality checks, and stocking sample inventory. The role also includes communicating and assisting with the preventive and predictive maintenance of saw equipment, performing other job functions as directed by the supervisor, and assisting Sample Clerks when needed.

Requirements

Be able to read, write, and count correctly
Basic Math, English, use a tape measure, weight scale, and micrometer
Be able to follow both written and verbal work instruction
Have good communication skills
Be detail oriented
Be able to change tasks, prioritize, and re-prioritize frequently and able to follow-up on work tasks as needed in a timely manner
Be able to bend, twist, push, pull, and lift (Up to 50lbs; anything heavier than that should be a two-person lift)
Wear proper Personal Protection Equipment (PPE) when applicable
Must work in an uncontrolled temperature environment
Operate a pallet jack
You must be able to perform all job-related duties on or about: 90 days

Responsibilities

Operate cutting equipment: Band saw, rotating knife saw and die press
Cut material to standard sample size; adjust as required
Maintain cut list schedule to sample inventory stock
Pull roll stock per the schedule
Load and Unload rolls as needed
Maintain organization of roll stock and shelves
Bagging cut samples properly following quality checks and requirements
Stocking sample inventory
Cut material into samples to keep shelves stocked
Responsible for communicating and assisting in the preventive and predictive maintenance of saw equipment
Perform other job functions as directed by supervisor
Quality check
Assist Sample Clerk’s when needed
Adhere to material cut standards
Review material after first cuts to inspect for quality of material
Must commit to creating a culture where partners are protecting partners- “You See Something, Say Something!”
Must comply with all company policies and procedures listed in the Leggett & Platt Employee Handbook
Report all incidents, accidents, and near-misses to your supervisor immediately
Assist in recognizing, responding, reporting, and eliminating hazards and assuring safety compliance
Must participate in: On-the- Job (OJT) Training documentation
Use of CAR/PARs (Corrective / Preventative Actions)
Incident/Accident/Near-Miss Investigations to determine root cause
Use of required PPE
Participation in training events
Good housekeeping in the work area and entire company grounds
Must understand and commit to: No personal cell phone use on the production floor; Active cell phone use does not go beyond breaks and lunches
No horseplay, yelling, or violence in the workplace
No eating or open drinks are allowed on the production floor
Commit to environmental preservation through: Stormwater Pollution Prevention
Participation in recycling initiatives
Proper use of waste containers
Participation in training events