Cobalt TN Repair Technician

MBI - Malibu Boats, Inc • Lenoir City, TN

4d • Onsite

About The Position

Repair of hulls and/or decks to Cobalt standards while following safety protocols. This role involves detailed inspection, sanding, buffing, fiberglass repair, gel coat application, and final boat inspection and finishing.

Requirements

• High school diploma or general degree (GED); or one to three months related experience and/or training; or equivalent combination of education and experience.
• Verbal instruction & comprehension are key in this role.
• Ability to read and interpret documented procedures.
• Basic Math
• Ability to recognize and solve problems on the go.
• Safety glasses and closed toe shoes required when on production floor.
• Chemical resistant gloves.
• Continuous/Frequent/Occasional/None Standing: 4 hours
• Continuous/Frequent/Occasional/None Walking: 4 hours
• Continuous/Frequent/Occasional/None Driving: 1 hours
• Employee Lifts and/or Carries: Maximum: 75 lbs
• Employee Lifts and/or Carries: Frequently: 25 lbs
• Employee Lifts and/or Carries: Occasionally: 50 lbs
• Employee uses Hands for repetitive activities: Simple Grasping: Right, Frequent
• Employee uses Hands for repetitive activities: Left, Frequent
• Employee uses Hands for repetitive activities: Pushing/Pulling: Right, Frequent
• Employee uses Hands for repetitive activities: Left, Frequent
• Employee uses Hands for repetitive activities: Fine Manipulation: Right, Frequent
• Employee uses Hands for repetitive activities: Left, Frequent
• Employee uses Feet for repetitive activities: Right: Frequent
• Employee uses Feet for repetitive activities: Left: Frequent
• Employee is required to perform these activities: Bending At Waist: Frequent
• Employee is required to perform these activities: Squatting: Frequent
• Employee is required to perform these activities: Climbing Ladders, Stairs: Frequent
• Employee is required to perform these activities: Kneeling On Ground: Frequent
• Employee is required to perform these activities: Reaching Above Shoulder: Frequent

Responsibilities

• Wipe down, buff, and inspect each part to identify flaws or damage.
• Sand and buff problem areas to make a smooth, shiny surface.
• Cut flaws out of fiberglass to remove problem areas.
• Mix gel coat and catalyst and fill in holes with the mixture.
• Paint over thin or damaged areas of gel coat to create a flawless surface.
• Correct crooked paint lines to create straight paint lines.
• Repair major areas in hull or deck to correct errors made while cutting.
• Repair areas that are damaged during assembly.
• Inspect, repair, and finesse the boat at the end of the line.

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED