Process Technician - 2nd Shift

VRC Engineered Solutions•Woodinville, WA

8d•$26 - $36•Onsite

About The Position

The Process Technician is responsible for setting up, programming, starting, troubleshooting, and optimizing injection molding machines, automation systems, and auxiliary equipment. This position plays a critical role in maintaining production efficiency, product quality, safety, and on-time delivery. The Process Technician must be proficient in machine setup, process startup, troubleshooting, and material handling activities necessary to support manufacturing operations.

Requirements

High School diploma or equivalent, with possession of basic math knowledge.
Ability to create MRO work orders in IQMS on molds and equipment when necessary.
Ability to operate electric crane used for setting and removing molds.
Must be forklift certified.
Ability to operate Rapi Stack in a safe manner.
Self-starter with a can-do attitude; always working in the best interest of CCM.
Must work well with minimal supervision independently to complete tasks as well as working as an active team member.
Ability to comply with instructions, prescribed routines, methods and/or practices.
Ability to effectively communicate with others.

Nice To Haves

Minimum 2-3 years of plastic injection molding processing experience preferred.
Experience with scientific molding principles preferred.
Knowledge of thermoplastic materials and drying requirements.
Experience troubleshooting molding defects including flash, short shots, sink, splay, burn marks, and warpage.

Responsibilities

Identify any unsafe condition(s) of machine and/or support equipment and notify maintenance or your supervisor immediately. Stop unsafe equipment from operation and lock out from power source.
Set up, start, operate, and troubleshoot molding machines, automation/robots, support equipment, and associated processes, and verify documentation for the job being installed or started.
Before starting the machine, clean all areas of the machine including bed, floor, and table of items from the previous run. Support equipment, documentation, and packaging from the previous run should also be put away before starting the machine.
Inspect mold for damage and lubrication of guide pins and bushings before starting.
Verify machine settings against the approved setup sheet and manufacturing plan prior to startup.
Provide operators with any additional information not covered in work instructions and ensure the correct manufacturing process is followed.
Troubleshoot and adjust machines as required to produce parts in accordance with the work instructions and manufacturing plan in a safe manner.
Act as a relief operator for breaks or as needed.
Complete all required startup documentation, including first-piece approval, last-piece verification, and manufacturing plan review, before releasing the machine to production.
Check that parts are being produced at a rate that meets or exceeds the standard listed in the manufacturing plan, including part and shot weight. Fill out a BOM change request form if necessary.
Notify the supervisor if scrap rates exceed the standards identified in the manufacturing plan or if excessive scrap occurs during startup.
Document and report process deviations that exceed established operating parameters.
Proficient to start up and troubleshoot all auxiliary equipment.
Proficient to build and troubleshoot EOA equipment.
Startup robotic and automation equipment and perform basic troubleshooting as required.
Provide training information and act as a resource to Material Handler & Setup Technician positions.
Stay up to date with technical developments and apply relevant knowledge to your job.
Conduct mold changeovers safely and efficiently.
Monitor and document critical process parameters.
Assist Engineering with mold trials, material evaluations, and validation activities.
Support continuous improvement and scrap reduction initiatives.
Train operators on process changes, startup requirements, and quality standards.
Participate in root cause investigations and corrective actions related to quality and equipment issues.