Process Engineer - Mechanical

TTM•San Diego, CA

16h•Onsite

About The Position

The Process Engineer is responsible for the implementation and maintenance of mechanical processes used to produce printed circuit boards, specifically in the drill, lamination and plating departments. This includes application engineering of processes developed by suppliers that are planned for use at TTM, installation of these processes and or equipment, establishment of operating conditions to produce product, daily monitoring of process conditions, and performing failure mode effect analysis to determine failure points of the process.

Requirements

Ability to read, write and communicate in English to the degree necessary to perform the job
Knowledge and application of statistical techniques for process control
Knowledge and application of failure mode effect analysis techniques as applied to both process development and process improvement
Must be able to lift 25 pounds without straining
Must have or be capable of obtaining and maintaining a U.S. Department of Defense (DoD) security clearance
Bachelor of Science degree in Mechanical Engineering or related degree
Must have a general knowledge of methods used to training people in the operation and theory of the processes they operate

Nice To Haves

Minimum of one year experience inspecting printed circuit boards preferred

Responsibilities

Research availability of mechanical processes to meet TTM technology needs
Write a project plan for process implementation
Implement process and perform failure mode effect analysis to establish correct operating conditions
Write all necessary procedures and instructions for process operation, maintenance and safety
Monitor process operation on a daily basis to assure consistency
Perform failure analysis and root cause analysis when product/process problems occur
Perform analyses on the processes when required