PB Mold Finish Technician

MBI - Malibu Boats, Inc•Harmony Heights, FL

2d•Onsite

About The Position

The PB Mold Finish Technician is responsible for successfully preparing Molds and Master patterns for production and mold lamination teams, while maintaining schedule and quality. This role involves ensuring all operations are performed safely and maintaining a clean, organized work environment. The technician will also train other employees and ensure adherence to approved processes.

Requirements

General knowledge and understanding of required power tools
Must be able to understand and execute top quality
Must be able to pass the strength/stress test and drug/alcohol screening contingent to the hiring process
Job requires standing and working in and around boats/molds throughout the entire day
Must work efficiently and in the safest manner possible, following all safety regulations at all time
Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals
Ability to write routine reports and correspondence
Ability to speak effectively before groups of customers or employees of organization
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals
Ability to compute rate, ratio, and percent and to draw and interpret bar graphs
Ability to solve practical problems and deal with a variety of concrete variables in situations where only limited standardization exists
Ability to interpret a variety of instructions furnished in written, oral, diagram, or schedule form

Nice To Haves

Use of quality assurance equipment, radius gauge, etc.
Surface inspection techniques
Composite fabrication
Sanding and buffing techniques

Responsibilities

Successfully prepare Molds and Master patterns for production and mold lamination teams
Maintain schedule and quality
Wet/Dry sand master/mold surfaces and buff to a polished surface
Identify surface defects
Sand prep surfaces for spray repairs
Tape and prepare molds and master patterns for spraying
Make sure that molds and masters are clean with no contaminates before spraying
Wax finished tools in preparation for production part or mold builds
Ensure all operations are performed safely
Maintain all areas and keep equipment clean, neat, and organized at all times
Conduct daily routine maintenance of equipment
Store all materials safely at the end of the day
Train Sander level employees
Conduct operations using TDC fabrication approved processes (ISPC)
Understand environmental compliance as it relates to material used in their area: chemical handling, usage, labeling, storage, and disposal
Supports continuous improvement utilizing Safety system, Kaizen, CAR system, and other problem-solving techniques
Responsible for the proper maintenance of all equipment used in their area and workplace organization using the 5S methodology
Identifies problems (i.e. material shortages, employee relations issues, etc.) within their scope and communicates to the group leader when additional assistance is needed