New Block Operator

Mueller Industries•Fulton, MS

About The Position

The New Block Operator operates the New Block machine, which includes a pointer machine and a block, to reduce the diameter and thickness of long rolls of copper tube. The operator performs approximately 100 draws or cycles during an eight-hour shift and monitors machine control panels throughout the shift. The role involves handling copper tube, changing and cleaning dies, documenting production, responding to jams, and removing scrap. Work includes frequent overhead reaching, standing and walking on slippery surfaces, bending, stooping, climbing, crawling, squatting, and kneeling. The operator is exposed to hot copper tubes at 170–178 degrees Fahrenheit and handles materials and equipment of various weights, sometimes with assistance.

Responsibilities

  • Operate the New Block machine to draw down the diameter and thickness of copper tube, completing approximately 100 draws or cycles per eight-hour shift.
  • Operate the Block/Spinner Block Machine control panels, reaching at or above shoulder level 500–600 times per shift, and constantly monitor the machine controls.
  • Insert tube tails into the pointer machine, applying up to 45 pounds of force at or above shoulder level.
  • Document die-size changes and production using a pen or pencil.
  • Change machine dies weighing up to 5 pounds approximately 18–20 times per shift, and clean lubricant from dies with solvent.
  • Reach at or above shoulder level while holding dies weighing up to 5 pounds approximately 18–20 times per day.
  • Use a 2-pound hammer and chisel to round tube tails, up to 100 times per shift.
  • Use a vice and hand cutter to cut tube samples approximately 3–4 times per shift.
  • Remove damaged tube from the carousel with assistance; the tube weighs more than 100 pounds, approximately 3–4 times per shift.
  • Lift and carry a 25–30-pound bucket of lubricant up to 200 feet from the bulk container to the machine once per shift.
  • Step onto and off the machine platform; when the tube handler is not working, lean over and reach into the machine to push the tube tail into the block.
  • Remove scrap copper tube from inside the machine and carousel area approximately once per shift, involving bending, stooping, climbing, and crawling.
  • Use foot controls to operate the straightener approximately 100 times per shift.
  • Cut and remove jammed tube pieces from the machine, requiring squatting, kneeling, or stooping to access the machine.
  • Remove cut tube points from the hopper and carry them to the scrap hopper, making approximately 15–20 trips over 45 feet.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service