Molder - 2nd shift

GE Aerospace•Jacksonville, FL

1d•Onsite

About The Position

This role at GE Aerospace’s Jacksonville site focuses on preparing, molding, curing, and finishing electronic component parts using precise formulas, fixtures, computerized ovens, and vacuum processes to meet strict operating standards. Candidates work from layouts and specifications, use a variety of tools and measurement devices, and actively participate in a lean, 5S teaming environment while meeting physical and safety requirements, including FAA/DOT screenings. GE offers strong career growth, day-one benefits, and education assistance within a diverse, climate-controlled facility that combines manufacturing with engine repair and overhaul.

Requirements

Actively participate in a teaming environment that uses lean and 5S practices to improve products and processes
Basic computer skills
Basic math skills
Basic ERP skills
Basic written and verbal communications skills
Use of measurement devices (i.e. scales, calculators, rulers)
Ability to frequently lift, carry, push and/or pull up to 25 lbs. with or without reasonable accommodations
Ability to stand for extended periods of time
Ability to work with hazardous materials and in an environment with fumes and chemicals
High School diploma or GED
Ability to be at least 18 years of age by the time of joining
Ability to prove that you meet the status of a U.S. Person as one of the following: U.S. lawful permanent resident, U.S. Citizen, have been granted asylee or refugee status

Nice To Haves

Excellent attendance history
Ability to produce error free products
Strives to meet or exceed job requirements

Responsibilities

Mix calculated compound ratios specified per formula and written specifications, blending materials, weighing, and heating as prescribed
Install parts in fixtures, create reservoir and install spacers as required
Operate computerized ovens per specifications to ensure curing times and cycles are maintained as required
Vacuum cycle the parts as required to evacuate air and humidity
Clean components to remove excess compound and flash to ensure cosmetic appearance
Perform shelf-life audits daily as required
Work from layouts, prints, specifications, route sheets and general instructions
Review requirements, select appropriate mold / fixtures and obtain necessary materials
Prepare work area to ensure clean working surface
Use of hand tools, weight scale, molds, fixtures, vibrator, vacuum chamber, ovens, air gun, solvents and arbor press
Check work at prescribed intervals to ensure compliance with operating standards