EC Manual Winder - 2nd shift

Vishay•Columbus, NE

12d•Onsite

About The Position

Vishay Dale Electronics in Columbus, Nebraska is seeking a Manual Winder to produce products that meet and exceed quality and customer expectations. The work involves welding, winding, and testing specified turns of wire onto resistor sub-assemblies to produce a specified resistance value. The position is on 2nd shift, Monday through Thursday, 3:30 p.m. to 2:00 a.m.; overtime is available as needed. The Manual Winder receives capped ceramic sub-assemblies, wire, and production orders from a Material Handler; operates machines and computers; places the correct wire on a spindle and threads it through the machine; enters winding parameters and order information into the computer; and loads trays or reels of capped ceramic sub-assemblies. The position requires prolonged sitting and attention to setup and work quality. Applicants must qualify as a U.S. Person under the cited federal regulations because the role involves access to regulated information.

Requirements

High school diploma or equivalent.
Ability to use judgment to analyze facts and circumstances surrounding processes or operations and determine appropriate actions within standard or accepted practices.
Ability to sit for prolonged periods while performing duties.
Ability to read, write, and perform arithmetic calculations.
Ability to concentrate and pay close attention to ensure proper setup and assess the quality of work.
Must qualify as a U.S. Person as defined by 22 C.F.R. §120.15, including a U.S. citizen, lawful permanent resident, refugee, or asylee.

Nice To Haves

Three months to one year of training in applying a range of complex or automated machinery, equipment, and processes.

Responsibilities

Produce products that meet and exceed quality and customer expectations.
Weld, wind, and test specified turns of wire onto resistor sub-assemblies to produce a specified resistance value.
Receive capped ceramic sub-assemblies, wire, and production orders from a Material Handler.
Turn on machines and computers.
Place the correct wire on the spindle and thread it through the machine.
Enter winding parameters and order information into the computer, including wire width, value, tolerance, thickness, and ohms per foot.
Load trays or reels of capped ceramic sub-assemblies into the machines.