Manual Lathe Operataor

Fastener Technology•Valley Glen, CA

5d•Onsite

About The Position

The Manual Lathe Operator is responsible for setting up, adjusting, and operating manual lathes to machine precision components to close tolerances. This role supports the production of both standard and custom parts by performing turning, drilling, threading, and finishing operations in accordance with engineering drawings and specifications. Success in this position requires strong mechanical aptitude, blueprint reading skills, and the ability to independently set up and troubleshoot machining operations.

Requirements

High school diploma or GED required.
Minimum 1 year of general production machining experience.
Strong understanding of manual lathe setup and operation.
Ability to read and interpret blueprints and technical drawings.
Solid shop math skills.
Experience working to close tolerances.
Strong troubleshooting and mechanical problem-solving skills.
Attention to detail and commitment to quality.
Ability to work independently with minimal supervision.

Nice To Haves

1–2 years of experience setting up and operating manual lathes or similar equipment preferred.

Responsibilities

Set up and operate manual lathes to perform turning, knurling, drilling, tapping, reaming, counter-boring, and deep drilling operations.
Install and secure tooling, collets, tool holders, stops, and indexing mechanisms.
Adjust tooling clearances, speeds, feeds, and timing to achieve required tolerances.
Perform test runs to verify setup and make necessary corrections.
Monitor machining processes and make adjustments to maintain dimensional accuracy.
Regulate cutting oil flow, remove chips, and maintain a clean and safe work area.
Perform basic machine maintenance, including oil changes and routine upkeep.
Diagnose machine malfunctions or setup issues and implement corrective actions.
Work from blueprints, specifications, and work instructions to produce conforming parts.
Inspect finished components using precision measuring equipment.