Machinist (Grades 7 - 9)
General Dynamics - Bath Iron Worksā¢Brunswick, ME
2dā¢$30 - $33
About The Position
This is an experienced position to work in the Machinist Trade. Machinists primarily set-up and operate machine shop equipment including (but not limited to): lathes, radial drills, grinders, presses, punch presses, cut-off saws, milling machines, HBM, VTL, rolls, sheers, brakes, and burning machines. Applicants hired into this position shall generally be able to operate most equipment with minimal training based on prior experience, including CNC operated equipment. Machinists may be assigned any of the Machinist Trade tasks.
Requirements
- Minimum 3 years demonstrated experience in the Machinist Trade.
- Must be able to read blue prints.
- Must be able to demonstrate knowledge and use of G-code.
- Must be able to read measuring tools: tape measure, inside and outside micrometers, Vernier or dial calipers, dial indicators, etc. and perform simple math calculations.
- Must meet the requirements of the Machinist physical task analysis.
- Technical school or at least two years of training in CNC machine operation.
- Knowledge of G-code.
Nice To Haves
- High School Diploma or GED
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
Upload and Match Resume
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
Number of Employees
5,001-10,000 employees
